Abstract:Silicon is considered one of the most promising negative electrode materials for future lithium ion batteries (LIBs) due to its high capacity (3579 mAh g-1 , based on Li15Si4) and its proper delithiation voltage (~ca. 0.4 V vs. Li/Li+). However, the huge volume change (~300 %) of Si during lithiation/delithiation leads to fracture and pulverization and of Si particles, continuous formation of solid-electrolyte interphase (SEI), and, consequently, fast capacity fade. Mechanical degradation remains a major barrier for commercializing Si electrodes. The most likely commercial Si electrodes, i.e., Si composite electrodes consisting of Si particles, conductive additives, polymeric binders, and porosity, are likely to exhibit mechanical properties and volume expansion/shrinkage behavior that are different from that of individual Si particles and Si thin films. Despite of a growing effort on electro-mechanical modeling of Si electrodes, the mechanical behavior and microstructure evolution of Si composite electrodes during lithiation/delithiation are largely unknown. To fill this gap, we developed an environmental nanoindentation system installed inside an argon-filled glovebox [Adv. Energy Mater., 10.1002/aenm.201702578 (2017) and Scr. Mater. 130, 191 (2017)] to measure Young’s modulus (E) and hardness (H) of Si composite electrodes during lithiation/delithiation under both dry and wet (the liquid electrolyte) conditions. In contrast to Si films, E and H values of Si/polyvinylidene fluoride (PVDF) electrodes and Si/Na-carboxymethyl cellulose (Na-CMC) electrodes, under both dry and wet conditions, increase with increasing Li concentration within each electrochemical cycle and decrease with increasing cycle number. The E and H values of the composite electrodes under dry condition are smaller than that under wet condition due to the softening of polymeric binders in the electrolyte. The porosity of both composite electrodes decreases with increasing Li concentration and increases with increasing cycle number. At the same state-of-charge (SOC), Si/Na-CMC electrodes have smaller porosity and better mechanical integrity than Si/PVDF electrodes, which is one of the reasons why Na-CMC works better than PVDF as a binder. The results show that mechanical integrity and microstructural stability play a vital role in improving the performance and durability of Si composite electrodes. The relationships between E, H, porosity, and SOC is useful to develop and validate electro-mechanical models of electrodes. They also provide valuable insight into developing high capacity Si electrodes. Furthermore, the environmental nanoindentation method can be used to measure the mechanical behavior of a wide range of electrochemical energy storage materials under realistic working conditions.

In Situ Measurements of Stress Evolution in Silicon Thin Films During Electrochemical Lithiation and Delithiation

In Situ Measurements of Stress-Potential Coupling in Lithiated Silicon

Stress Evolution in Composite Silicon Electrodes during Lithiation/Delithiation

In Situ Atomic-Scale Imaging of Electrochemical Lithiation in Silicon.

On plastic deformation and fracture in Si films during electrochemical lithiation/delithiation cycling

In situ method for stress measurements in film-substrate electrodes during electrochemical processes: key role of softening and stiffening

Real-time Measurement of Stress and Damage Evolution During Initial Lithiation of Crystalline Silicon

Micro-Raman Stress Characterization of Crystalline Si as a Function of the Lithiation State

In-situ measurements of electrochemical stress/strain fields and stress analysis during an electrochemical process

Thin-film electrodes for high-capacity lithium-ion batteries: influence of phase transformations on stress

Experimental measurement of electro-chemo-mechanical properties of a composite silicon electrode in lithium ion batteries

In situ Measurement of Biaxial Modulus of Si Anode for Li-ion Batteries

In Situ Measurement of Mechanical Property and Stress Evolution in a Composite Silicon Electrode

Real-time Stress Measurements in Germanium Thin Film Electrodes during Electrochemical Lithiation/delithiation Cycling

Probing Stress States in Silicon Nanowires During Electrochemical Lithiation Using In Situ Synchrotron X-Ray Microdiffraction

Analysis of Lithiation and Delithiation Kinetics in Silicon

Strain-Induced Lithium Losses in the Solid Electrolyte Interphase on Silicon Electrodes

Molecular dynamic investigation of the structure and stress in crystalline and amorphous silicon during lithiation

Electrochemical Stiffness Changes in Lithium Manganese Oxide Electrodes

Stress Effects on Lithiation in Silicon

Stress Mitigation During the Lithiation of Patterned Amorphous Si Islands