Abstract:Recent progress in nanotechnology has enabled to design the advanced functional micro-/nanostructures utilizing the unique properties of ultrathin films. To ensure these structures can reach the expected functionality, it is necessary to know the density, generated internal stress and the material properties of prepared films. Since these films have thicknesses of several tens of nm, their material properties, including density, significantly deviate from the known bulk values. As such, determination of ultrathin film material properties requires usage of highly sophisticated devices that are often expensive, difficult to operate, and time consuming. Here, we demonstrate the extraordinary capability of a microcantilever commonly used in a conventional atomic force microscope to simultaneously measure multiple material properties and internal stress of ultrathin films. This procedure is based on detecting changes in the static deflection, flexural and torsional resonant frequencies, and the corresponding quality factors of the microcantilever vibrating in air before and after film deposition. In contrast to a microcantilever in vacuum, where the quality factor depends on the combination of multiple different mechanical energy losses, in air the quality factor is dominated just by known air damping, which can be precisely controlled by changing the air pressure. Easily accessible expressions required to calculate the ultrathin film density, the Poisson’s ratio, and the Young’s and shear moduli from measured changes in the microcantilever resonant frequencies, and quality factors are derived. We also show that the impact of uncertainties on determined material properties is only minor. The validity and potential of the present procedure in material testing is demonstrated by (i) extracting the Young’s modulus of atomic-layer-deposited TiO2 films coated on a SU-8 microcantilever from observed changes in frequency response and without requirement of knowing the film density, and (ii) comparing the shear modulus and density of Si3N4 films coated on the silicon microcantilever obtained numerically and by present method.

Self-contained in-vacuum in situ thin film stress measurement tool

A new method for high resolution curvature measurement applied to stress monitoring in thin films

Ultra-sensitive, Highly Reproducible Film Stress Characterization Using Flexible Suspended Thin Silicon Plates and Local Curvature Measurements

A Highly Sensitive Local Curvature Metrology for Internal Stress Detection in Thin Films

Study of Local Stress Using Stress-Absorbing Si Diaphragm

Simple Non-Destructive Method of Ultrathin Film Material Properties and Generated Internal Stress Determination Using Microcantilevers Immersed in Air

In Situ and Real-Time Tensile Testing of Thin Films Using Double-Field-of-view Electronic Speckle Pattern Interferometry

Evaluating Interface Effect On Stresses In Thin Films By A Local Curvature Metrology With High Accuracy And Resolution

A self-referenced interferometer for in situ cryogenic wafer curvature measurements

Internal Stress Measurement by Laser Feedback Method

A Novel Approach to Study Patterned Thin Film Local Stress for Microelectronics Application

Measurement of Residual Stresses in Pulsed Laser Deposited Thin Films

New avenues for residual stress analysis in ultrathin atomic layer deposited free-standing membranes through release of micro-cantilevers

Simultaneous Determination of the Residual Stress, Elastic Modulus, Density and Thickness of Ultrathin Film Utilizing Vibrating Doubly Clamped Micro-/Nanobeams

Fabrication and Measurement of Test Structures to Monitor Stress in SU-8 Films

Residual Stress Measurement on a MEMS Structure With High-Spatial Resolution

Immersed Cantilever Apparatus for Mechanics and Microscopy

New Methods for Measuring Mechanical Properties of Thin Films in Micromachining: Beam Pull-in Voltage (VPI) Method and Long Beam Deflection (LBD) Method

New Internal Stress Driven on-Chip Micromachines for Extracting Mechanical Properties of Thin Films

Simultaneous Micro-Stress and Strain Measurement with an Optical Microscope

Residual Stress Measurement in Thin Films Using a Slitting Method with Geometric Phase Analysis under a Dual Beam (FIB/SEM) System