Abstract:Because it is magnet-free and can achieve a high integration level, the switched-capacitor (SC) converter acting as a direct current transformer has many promising applications in modern electronics. However, designing an SC converter with large current capability and high power efficiency is still challenging. This paper proposes a dual-branch SC voltage divider and presents its integrated circuit (IC) implementation. The designed SC converter is capable of driving large current load, thus widening the use of SC converters to high-power applications. This SC converter has a constant conversion ratio of 1/2 and its dual-branch interleaved operation ensures a continuous input current. An effective on-chip gate-driving method using a capacitively coupled floating-voltage level shifter is proposed to drive the all-NMOS power train. Due to the self-powered structure, the flying capacitor itself is also a bootstrap capacitor for gate driving and thus reduces the number of needed components. A digital frequency modulation method is adopted and the switching frequency decreases automatically at light load to improve light load efficiency. The converter IC is implemented using a 180 nm triple-well BCD process. Experimental results verify the effectiveness of the dual-branch interleaved operation and the self-powered gate-driving method. The proposed SC divider can drive up to 4 A load current with 5–12 V input voltage and its power efficiency is as high as 96.5%. At light load, using the proposed optimization method, the power efficiency is improved by 30%.

Design Considerations of Distributed and Centralized Switched-Capacitor Converters for Power Supply On-Chip

Design and Simulation of a PFM-PWM Hybrid Controller for DCDC Converter with CLLC Topology

Design and Implementation of High-Efficiency and Low-Power DC-DC Converter with PWM/PFM Modes

Structural Design of A Five-Level Hybrid Active Npc Converter for High Power Density Motor Drives

Early-Stage Planning of Switched-Capacitor Converters in a Heterogeneous Chip

An Integrated Design of Power Converters for Electric Vehicles.

Soft-switching three-phase matrix based isolated AC-DC converter for DC distribution system

Soft-Switching Single-Stage Current-Fed Full-Bridge Isolated Converter for High Power Ac/Dc Applications

Design of Ac/dc Converter for Bidirectional On-Board Battery Charger with Minimizing the Amount of SiC MOSFET

Design Considerations of Soft-Switched Buck PFC Converter With Constant On-Time (COT) Control

A Monolithic Cmos 5v/1v Switched Capacitor Dc-Dc Step-Down Converter

Detailed Study of A 5v/1v, Four Stage Switched Capacitor Converter Suitable for Integration

Analysis and design considerations of two-stage AC-DC LED driver without electrolytic capacitor

A 12-Level Series-Capacitor 48-1V DC–DC Converter With On-Chip Switch and GaN Hybrid Power Conversion

A High Performance 48-to-8 V Cascaded Switched-Capacitor Converter for Data Center Applications

Resonant-Switched Capacitor Converters for Chip-Scale Power Delivery: Design and Implementation

A Large-Current, Highly Integrated Switched-Capacitor Divider with a Dual-Branch Interleaved Topology and Light Load Efficiency Improvement

Design Consideration of the Voltage Stress Clamping Rectifier Configuration Used for the Front-End Dc/Dc Converter with the Capacitive Output Filter

An Auxiliary Switched-Capacitor Power Converter (Scpc) Applied In Stacked Digital Architecture For Energy Utilization Enhancement

A Common Grounded Non-Isolated ASISC High Gain DC-DC Converter with Oscillation Mitigation Across Switches

A DC-DC Converter with Switched-Capacitor Delay Deadtime Controller and Enhanced Unbalanced-Input Pair Zero-Current Detector to Boost Power Efficiency