Abstract:This paper proposes a concept of electrolytic capacitor-less light-emitting diode (LED) driver, which converts the commercial ac voltage to a pulsating current with twice the line frequency driving high-brightness LEDs. As no electrolytic capacitor is used, this driver possesses the unique advantage of long lifetime to match with that of LEDs. A method of injecting the third and fifth harmonics into the input current to reduce the peak-to-average ratio of the output current is also proposed. While ensuring that the input power factor is higher than 0.9 to meet regulation standards such as ENERGY STAR, the proposed method allows the peak-to-average ratio of the output current to be reduced to 1.34 theoretically, which is beneficial for the safe operation of the LEDs. As an example, a flyback-based electrolytic capacitor-less LED driver is proposed, and its operation is analyzed. In order to inject the third and fifth harmonics into the input current, the function of the duty cycle in a half-line cycle is derived. It is then simplified to a fitting function, which can be easily implemented with the input voltage sensing. A 25 V, 0.35 A output prototype is built and tested in the laboratory, and the experimental results are presented to verify the effectiveness of the electrolytic capacitor-less LED driver and its control method.

Analysis and design considerations of two-stage AC-DC LED driver without electrolytic capacitor

An Electrolytic-Capacitorless And Inductorless Ac Direct Led Driver With Power Compensation

A Single-Stage Primary Side Controlled Flyback LED Driver

A linear constant current LED driver without off-chip inductor and capacitor

Electrolytic-capacitor-less high-power LED driver

A Capacitorless and Low‐Optical‐Flicker AC Direct LED Driving IC and System Applied to Street Lighting

Bipolar Ripple Cancellation Method to Achieve Single-Stage Electrolytic-Capacitor-Less High-Power LED Driver

Single-Stage LED Driver Achieves Electrolytic Capacitor-Less and Flicker-Free Operation With Unidirectional Current Compensator

A New Electrolytic Capacitor-less LED Driver with Coupled-Inductor

A Capacitor-Isolated Led Driver with Inherent Current Balance Capability

Analysis and Design Considerations for A High Power Buck Derived Led Driver with Extended Output Voltage and Low Total Harmonic Distortion

An Electrolytic Capacitor-Less High Power Factor LED Driver Based on a “One-and-a-Half Stage” Forward-Flyback Topology

High Power Factor Light-emitting Diode Driver on Digital Signal Processor Without Electrolytic Capacitor for High-power Lighting

A Method of Reducing the Peak-to-Average Ratio of LED Current for Electrolytic Capacitor-Less AC–DC Drivers

A Dimmable and Power-Compensated AC Direct LED Driver with High Efficiency

Luminous Efficiency of Ripple Current Power Driving High Power LED

Design Considerations for Dual-Output Quasi-Resonant Flyback LED Driver With Current-Sharing Transformer

Analysis and Design Considerations of LLCC Resonant Multioutput DC/DC LED Driver With Charge Balancing and Exchanging of Secondary Series Resonant Capacitors

High power non-electrolytic capacitor LED driver with three ports based on energy distribution

Analysis and Design Considerations for an Improved BCM Buck Ac-Dc LED Driver with High Output Voltage and Low Total Harmonic Distortation

LED Driver Achieves Electrolytic Capacitor-Less and Flicker-Free Operation With an Energy Buffer Unit