Abstract:Densified wood (DW) is a recently developed material with excellent mechanical properties, considered as an ideal construction material for high-rise timber buildings. However, its flame spread behavior has not been well understood limiting its applications. This work for the first time experimentally and analytically investigates the horizontal flame spread behavior of DW. The influences of material structural characteristics (e.g. density) on heat transfer characteristics are focused. Thermally thin DW with density ranges of 441–1025 kg/m 3 and a constant thickness of 2 mm were tested. The flame spread rate, mass loss rate (MLR) and flame height decreased with the increased wood density. A power-law correlation between the dimensionless MLR and dimensionless density is proposed, which well predicts the experiments with an R 2 of 0.922. The increased wood density decreases flame height and reduces flame radiation. The gas-phase heat transfer shifts from radiation-dominant to convection-dominant. The longitudinal and radial thermal conductivities of DW increased with wood density. Empirical equations are optimized to predict the thermal conductivities of DW with R 2 of 0.870 (longitudinal) and 0.837 (radial). The preheating zone length and the temperature gradient per unit length don't vary significantly with wood density. Their values are averaged to 25.62 mm and 9.312 K/mm respectively. The longitudinal heat conduction is increased with the wood density due to the increased conductivity. However, this conduction increase is lower than the radiation decrease as the wood density increases. Thus, the total heat flux is slightly decreased with the wood density. The gas phase heat transfer dominates the flame spread. However, the longitudinal heat conduction can account for more than half of the gaseous heat transfer, and thus cannot be negligible. Results of this work improve the understanding of DW flame spread, which helps to evaluate the fire behaviors of timber construction.

X-ray densitometer for vertical density profile of Wood-based Panel

A new method for nondestructive evaluation of solid wood moisture content based on dual-energy X-ray absorptiometry

New scanning densitometer

Potential error in density profile measurements for wood composites

Density profiles of novel kraft pulp and TMP based foam formed thermal insulation materials observed by X-ray tomography and densitometry

Intra-Ring Wood Density and Dynamic Modulus of Elasticity Profiles for Black Spruce and Jack Pine from X-ray Densitometry and Ultrasonic Wave Velocity Measurement

Design of Solid-State Detector Modules for High Energy X-ray Imaging

Investigation on the char crack growth of densified wood

Horizontal flame spread behavior of densified wood: Effect of structural characteristics

Quantitative X-ray fluorescence micro-analysis of wood samples and visualization of tree rings

Determination of concentrations of mobile volatile organic compounds, the partition coefficient and the diffusion coefficient in dry building materials

Experimental Measurements of Thermal Conductivity of Wood Species in China: Effects of Density, Temperature, and Moisture Content

Three-dimensional geometry, pore parameter, and fractal characteristic analyses of medium-density fiberboard by X-ray tomography, coupling with scanning electron microscopy and mercury intrusion porosimetry

Atomic Number and Electron Density Measurement Using a Conventional X-ray Tube and a CdTe Detector

Design of Beam Profile Monitor Used at the Xi'an Proton Application Facility (Xipaf)

APPLICATION OF 60 Co SOURCE TO INDUSTRIAL DIGITAL RADIOGRAPHIC NONDESTRUCTIVE TESTING SYSTEM

Experimental Verification of Validity of Parameters of X-ray Module for Profile Gauge

A wide fan-beam dual-energy X-ray absorptiometry for forearm

An Investigation on Formaldehyde Emission Characteristics of Wood Building Materials in Chinese Standard Tests: Product Emission Levels, Measurement Uncertainties, and Data Correlations between Various Tests

A New Approach for Discriminative Measurements of Different Components of External Ionizing Radiation.

A New Method for Determining the Initial Mobile Formaldehyde Concentrations, Partition Coefficients, and Diffusion Coefficients of Dry Building Materials