Abstract:The qualitative evaluation of harvested raw logs and sawlogs is mainly based on the quantitative and qualitative evaluation of the visible macroscopic features of the wood. Modern methods allow for the analysis of whole logs by means of computed tomography. These devices can analyze the internal qualitative features of wood that are not visible on the external structures of the logs. The aim of this work was to evaluate the detection accuracy of a CT-scanning device intended for scanning logs on the internal qualitative features of wood using model trunks. Two logs of beech and oak with a length of 4 m were selected for the analysis, based on availability. Qualitative features were identified through computed tomography scanning, visually identified on cut sections, and then manually measured in accordance with applicable legislation. Relatively good agreement was demonstrated for the detected features in terms of identifying their location (dimension in millimeters from the end of the log). For this parameter, the average differences were 0.90% on the beech log and only 1.21% on the oak log. Relatively high accuracy was shown via CT detection of qualitative features in the beech section (with average differences in dimensions of only 3.5%). In the case of the oak log, the dimensions of the quality features were significantly overestimated. These results indicate that CT scanning technology may have a problem with some hardwood species. It was primarily developed for coniferous tree species, and software algorithms are, therefore, not yet fully adapted to the precise detection of the dimensions of individual quality features. Despite the detected differences, it was confirmed that the CT technology of scanning harvested wood can have a fundamental impact on optimization procedures in the recovery and processing of wood. Renting a scanning line for a certain capacity of wood volume appears to be a deployment option for forestry operations and smaller wood processing operations. Thus, this technology can become an important factor in improving the economic evaluation of the final production of wood.

Quantitative X-ray fluorescence micro-analysis of wood samples and visualization of tree rings

Tree Core Analysis with X-ray Computed Tomography

Near Infrared Hyperspectral Imaging Applied to Mapping Chemical Composition in Wood Samples

Detection of Knot Defects on Coniferous Wood Surface Using Near Infrared Spectroscopy and Chemometrics

Non-destructive wood identification using X-ray μCT scanning: which resolution do we need?

Automated quantification of the impact of the wood-decay fungus Physisporinus vitreus on the cell wall structure of Norway spruce by tomographic microscopy

Exploring high frequency densitometry calibration functions for different tree species

Intra-Ring Wood Density and Dynamic Modulus of Elasticity Profiles for Black Spruce and Jack Pine from X-ray Densitometry and Ultrasonic Wave Velocity Measurement

[The analysis of wood microfibril angle by near infrared spectroscopy and X-ray diffractometry].

Improvements in the PIXE system of the CENTA laboratory with application in the contamination studies of tree rings in Slovakia

Determination of Basic Density and Moisture Content of Loblolly Pine Wood Disks Using a near Infrared Hyperspectral Imaging System

[Application of micro-computed tomography (μCT)in quantifying xylem vessels of broadleaved trees]

Measuring Radial Variation in Basic Density of Pendulate Oak: Comparing Increment Core Samples with the IML Power Drill

Pine Bark Pixe Analysis - A New Method To Study Long-Term Environmental-Changes

Pore space analysis of beech wood: the vessel network

Techniques for high resolution imaging of wood structure: a review

Determination of macro‐ and microelements concentrations by wavelength‐dispersive X‐ray fluorescence spectrometry in the objects of the technogenic ecosystem

The Accuracy of CT Scanning in the Assessment of the Internal and External Qualitative Features of Wood Logs

Microstructure of chemically modified wood using X-ray computed tomography in relation to wetting properties

Predicting strength of Norway spruce and Scots pine sawn timber using discrete X-ray log scanning, optical board scanning, traceability, and partial least squares regression

Three-dimensional modeling of moisture transport in wood using near-infrared hyperspectral imaging and X-ray computed tomography in conjunction with finite element analysis