Abstract:Abstract This work was undertaken to investigate the feasibility of using near infrared spectroscopy (NIR) and partial least squares regression (PLS) as a tool to characterize the basic wood properties of Norway Spruce (Picea abies (L.) Karst.). The wood samples originated from a trial located in the province of Västerbotten in Sweden. In this trial, the effects of birch shelterwoods (Betula pendula Roth) of different densities on growth and yield in Norway spruce understorey were examined. All Norway spruce trees in each shelterwood treatment were divided into three growth rate classes based on diameter at breast height (1.3 m) over bark. Five discs were cut from each tree (i.e. from the root stem, and at 20%, 40%, 60%, and 80% of the total height). The discs from 40% tree height were used (i.e., where the largest variations in annual ring widths and wood density were found). A total of 27 discs were selected. The discs were used for measuring annual ring widths, wood density, average fiber length and the fiber length distributions. Milled wood samples prepared from the discs were used for recording NIR spectra. PLS regression was used to generate prediction models for the wood properties (Y-matrix) and NIR spectra (X-matrix) as well as between the wood properties (Y-matrix) and the fiber length distributions (X-matrix). One set of models was generated using untreated spectra and fiber length distributions. For a second set of models the structure in the X-matrix, which was orthogonal to the matrix described by the wood properties, was eliminated using a soft target rotation technique called orthogonal signal correction (OSC). The PLS model obtained using “raw” untreated NIR spectra and fiber length distributions had a poor modeling power as evidenced by the cumulative Q2 values. For the PLS models based on untreated NIR spectra the cumulative Q2 values ranged from a minimum of 16% (wood density) to a maximum of 46% (no. of annual rings). Orthogonal signal correction of the X-matrix (NIR spectra or fiber length distributions) gave PLS models with a modeling power corresponding to cumulative Q2 values well in excess of 70%. The improvement in predictive ability accomplished by the OSC procedure was verified by placing four of the 27 observations in an external test set and comparing RMSEP values for the test set observations without OSC and with OSC.

[The analysis of wood microfibril angle by near infrared spectroscopy and X-ray diffractometry].

Characterization and Prediction of Mechanical and Chemical Properties of Luanta Fir Wood with Vacuum Hydrothermal Treatment

Rapid Determination of Componential Contents and Calorific Value of Selected Agricultural Biomass Feedstocks Using Spectroscopic Technology

Detection of Knot Defects on Coniferous Wood Surface Using Near Infrared Spectroscopy and Chemometrics

Rapid prediction of acid detergent fiber, neutral detergent fiber, and acid detergent lignin of rice materials by near-infrared spectroscopy.

Determination of Hemicellulose, Cellulose and Lignin Content Using Visible and Near Infrared Spectroscopy in Miscanthus Sinensis.

Spectrometric prediction of wood basic density by comparison of different grain angles and variable selection methods

Radial variation and prediction model in crystallinity and microfibril angle of Michelia macclurei

Multivariate Modeling Dahurian Larch Plantation Wood Density Based on Near Infrared Spectroscopy

WD-1D-VGG19-FEA: An Efficient Wood Defect Elastic Modulus Predictive Model

Rapid assessment of physical properties and chemical composition of thermally modified wood by mid-infrared spectroscopy

Prediction of holocellulose and lignin content of pulp wood feedstock using near infrared spectroscopy and variable selection

Rapid characterization of woody biomass digestibility and chemical composition using near-infrared spectroscopy

Rapid estimation of wood density and total extractives of two important Dalbergia species using near-infrared (NIR) spectroscopy and multivariate analysis

Determination of Coniferous Wood’s Compressive Strength by SE-DenseNet Model Combined with Near-Infrared Spectroscopy

Prediction of basic wood properties for Norway spruce. Interpretation of Near Infrared Spectroscopy data using partial least squares regression

Use of Visible and Near Infrared Spectroscopy to Predict Klason Lignin Content of Bamboo, Chinese Fir, Paulownia, and Poplar

Identification of Five Similar Cinnamomum Wood Species Using Portable Near-Infrared Spectroscopy

Improving feedstock quality control in formaldehyde-based resin and wood-based panel production through near infrared spectroscopy

Quantitative prediction of moisture content distribution in acetylated wood using near-infrared hyperspectral imaging

Near Infrared Hyperspectral Imaging Applied to Mapping Chemical Composition in Wood Samples