Experimental study on the permeability and resistance characteristics in the packed bed with the multi-size irregular particle applied in the sinter vertical waste heat recovery technology

Sizong Zhang,Zhi Wen,Xunliang Liu,Xiaohong Liu,Shuai Wang,Hui Zhang
DOI: https://doi.org/10.1016/j.powtec.2021.02.027
IF: 5.64
2021-05-01
Powder Technology
Abstract:<p>The gas flow resistance in the packed bed of multi-size irregular particles applied in the sinter vertical cooling process is measured experimentally to analyze the effect of the equivalent particle diameter (<em>d</em><sub>p,m</sub>) and the particle size distribution on the permeability and resistance characteristics. Results show that the flow resistance per unit bed height (Δ<em>P</em>/<em>L</em>) decreases with the reduction of <em>d</em><sub>p,m</sub>. However, the decrement of Δ<em>P</em>/<em>L</em> ascends first and then descends due to the comprehensive influence of the bed voidage and the particle size distribution, which is quite different from that in the mono-size sinter bed. Compared to the mono-size sinter packed bed, the bed permeability of the multi-size sinter mixture is lower under the same equivalent particle diameter. The particle size distribution of the multi-size sinter mixture has a great impact on the gas flow regime, especially at the low gas velocity. This makes the gas flow resistance in the packed bed of the multi-size sinter bigger. Since the mean error of the previous resistance correlations is greater than 44.79%, the resistance correlation applicable for the multi-size sinter is obtained by modifying the Ergun equation with the mean error less than 10%.</p>
engineering, chemical
What problem does this paper attempt to address?