Abstract:Determination of heat transfer coefficients for flowing packed particle beds is essential to the design of particle heat exchangers, and other thermal processes. While such dense granular flows fall into the well-known plug-flow regime, the discrete nature of granular materials alters the thermal transport processes in both the near-wall and bulk regions of flowing particle beds from their stationary counterparts. As a result, heat transfer correlations based on the stationary particle bed thermal conductivity could be inadequate for flowing particles in a heat exchanger. Earlier works have achieved reasonable agreement with experiments by treating granular media as a plug-flow continuum with a near-wall thermal resistance in series. However, the properties of the continuum were often obtained from measurements on stationary beds owing to the difficulty of flowing bed measurements. In this work, it was found that the properties of a stationary bed are highly sensitive to the method of particle packing and there is a decrease in the particle bed thermal conductivity and increase in the near-wall thermal resistance, measured as an effective air gap thickness, on the onset of particle flow. These variations in the thermophysical properties of stationary and flowing particle beds can lead to errors in heat transfer coefficient calculations. Therefore, the heat transfer coefficients for granular flows were calculated using experimentally determined flowing particle bed thermal conductivity and near-wall air gap for ceramic particles -CARBOCP40/100(275 um), HSP40/70(404um) and HSP16/30(956um); at velocities of 5-15mms-1; and temperatures of 300-650C. The thermal conductivity and air gap values for CP40/100 and HSP40/70 were further used to calculate heat transfer coefficients across different particle bed temperatures and velocities for different parallel-plate heat exchanger dimensions.

Wall Effects on the Pressure Drop in Packed Beds of Irregularly Shaped Sintered Ore Particles

Experimental study on pressure drop of packed beds with binary sintered ore particle mixtures

Pressure drop in a packed bed with sintered ore particles as applied to sinter coolers with a novel vertically arranged design for waste heat recovery

Investigation of pressure drop in a cocurrent downflow three-phase moving bed

Determination of Pressure Drop for Air Flow Through Sintered Metal Porous Media Using A Modified Ergun Equation

Frictional Resistance Investigation of Sco2 and a Semi-Empirical Friction Factor Correlation Based on Wall-of-the-law

Measurement and Correlation of Pressure Drop Characteristics for Air Flow Through Sintered Metal Porous Media

CFD Analysis of Wall Effects in Packed Beds with Small Tube-to-sphere Diameter Ratio

Experimental and numerical investigation of solid behavior in a gas–solid turbulent fluidized bed

Wall Effect on Pressure Drop in Packed Beds

Effects of Interparticle Forces on Fluidization Characteristics in Liquid-Containing and High-Temperature Fluidized Beds

Determination of Pressure Drop Correlation for Air Flow through Packed Bed of Sinter Particles in Terms of Euler Number

Experimental study on the permeability and resistance characteristics in the packed bed with the multi-size irregular particle applied in the sinter vertical waste heat recovery technology

The effect of particle arrangement on the direct heat extraction of regular packed bed with numerical simulation

Experimental Study and X-Ray Microtomography Based Cfd Simulation for the Characterization of Pressure Drop in Sinter Bed

Experimental Investigation on Local Particle Volume Fractions Distribution in Offset-Exit Circulating Fluidized Bed

A Comprehensive Characterization on the Structural and Thermophysical Properties of Sintered Ore Particles Toward Waste Heat Recovery Applications

Gas and Powder Flow Characteristics of Packed Bed: A Two-way Coupled CFD-DEM Study

Effect of Operating Parameters on Gas‐Solid Hydrodynamics and Heat Transfer in a Spouted Bed

Heat Transfer Coefficients of Moving Particle Beds from Flow-Dependent Particle Bed Thermal Conductivity and Near-Wall Resistance

Solids mass flux and mean dynamic solids hold-up in the packed section of the gas-solid-solid circulating fluidized bed