Abstract:The following paper provides a multi-band channel measurement analysis on the frequency range (FR)3. This study focuses on the FR3 low frequencies 6.5 GHz and 8.75 GHz with a setup tailored to the context of integrated sensing and communication (ISAC), where the data are collected with and without the presence of a target. A method based on multiple signal classification (MUSIC) is used to refine the delays of the channel impulse response estimates. The results reveal that the channel at the lower frequency 6.5 GHz has additional distinguishable multipath components in the presence of the target, while the one associated with the higher frequency 8.75 GHz has more blockage. The set of results reported in this paper serves as a benchmark for future multi-band studies in the FR3 spectrum.

What problem does this paper attempt to address?

The problem that this paper attempts to solve is to understand and optimize the propagation characteristics of the FR3 frequency band (7 - 24 GHz) in a multi - band environment, especially its performance in target detection and integrated sensing and communication (ISAC) applications. Specifically: 1. **Frequency Selection and Congestion Problem**: With the congestion in the frequency bands below 6 GHz and the problems of limited transmission range and high blockage sensitivity in the millimeter - wave band (mmWave), the FR3 frequency band, as a key resource for 5G - Advanced and 6G networks, provides larger bandwidth and better propagation characteristics. However, part of the FR3 frequency band is occupied by existing services, such as military radars, radio astronomy, and satellite communications. Therefore, it is necessary to study how to share these spectrum resources. 2. **Multi - band Channel Measurement**: In order to better understand and utilize the FR3 frequency band, researchers need to conduct detailed multi - band channel measurements. Although existing measurement campaigns have collected some data on the channel impulse response (CIR), there are still significant gaps in target detection, especially in applications in complex environments. 3. **Target Detection and Multipath Effect**: This paper pays special attention to the behavior of the FR3 frequency band in target detection, especially when the line - of - sight (LoS) is weak or partially blocked. By comparing the multipath channel measurement results at different frequencies, researchers hope to reveal the influence of the target on the background channel (or clutter) and develop more adaptive models to achieve accurate target detection. ### Research Methods To achieve the above - mentioned goals, the author has carried out the following work: - **Multi - band and Multi - antenna Measurement**: Conduct multi - band and multi - antenna channel measurements in the low - frequency region of the FR3 frequency band (6.5 GHz and 8.75 GHz), using the newly developed Pi - Radio radio - frequency front - end device. - **Data Processing and Analysis**: Use the MUSIC algorithm to estimate the delay of the discrete - time channel impulse response, and use the K - means clustering algorithm to classify the multipath delays to highlight the main multipath components and cluster them into delay groups. - **Experimental Verification**: Conduct experiments in the indoor environment of New York University Wireless Laboratory (NYU WIRELESS). By changing the positions of the transmitter (TX), receiver (RX) and the target and the antenna directions, a large amount of data has been collected. ### Main Findings - **6.5 GHz Frequency Band**: When the target exists, the channel shows more distinguishable multipath components. - **8.75 GHz Frequency Band**: When the target exists, the channel shows more blocking effects. These findings indicate that the multipath components at different frequencies have different responses to the existence of the target, which provides a valuable reference for future multi - band measurements and ISAC applications.

An Experimental Multi-Band Channel Characterization in the Upper Mid-Band

Fundamental Limits Analysis of Multiband Sensing

Near-Field Measurement System for the Upper Mid-Band

Measurement-based Characterization of ISAC Channels with Distributed Beamforming at Dual mmWave Bands and with Human Body Scattering and Blockage

Fundamental Limits and Optimization of Multiband Sensing

Multi-channel Photonic THz-ISAC System Based on Integrated LFM-QAM Waveform

Upper Mid-Band Channel Measurements and Characterization at 6.75 GHz FR1(C) and 16.95 GHz FR3 in an Indoor Factory Scenario

Multiple-Frequency-Bands Channel Characterization for In-vehicle Wireless Networks

220 GHz Urban Microcell Channel Measurement and Characterization on a University Campus

Channel Measurement and Characterization with Modified SAGE Algorithm in an Indoor Corridor at 300 GHz

Hybrid Channel Modeling and Environment Reconstruction for Terahertz Monostatic Sensing

Near-Field Channel Characterization for Mid-band ELAA Systems: Sounding, Parameter Estimation, and Modeling

Characterization of Indoor RIS-Assisted Channels at 304 GHz: Experimental Measurements, Challenges, and Future Directions

Large-scale Outdoor Cell-free mMIMO Channel Measurement in an Urban Scenario at 3.5 GHz

Ultra-wide Band Wireless Body Area Network Channel Measurements and Modeling

Correlation-based Dual-band THz Channel Measurements and Characterization in a Laboratory

Multi-Scenario Broadband Channel Measurement and Modeling for Sub-6 GHz RIS-Assisted Wireless Communication Systems

300 GHz Wideband Channel Measurement and Analysis in a Lobby

Characterization of Spatial-Temporal Channel Statistics from Measurement Data at D Band

An empirical study of ISAC channel characteristics with human target impact at 105 GHz

Directional Wideband Channel Measurements at 28 GHz in an Industrial Environment