Abstract:The vapor-box is a liquid metal based design to cope with the demanding conditions of the divertor. This design relies on the recirculation of lithium by evaporation and condensation. An issue to this approach is the safety risks of Li-D/T formation and co-deposition on both the vapor-box walls - leading to possible recirculation impedance- and on the first wall leading to unacceptable tritium retention. Additively manufactured tungsten Capillary Porous Structure (CPS) samples filled with Li were exposed to high heat flux D plasmas in the linear plasma device Magnum-PSI and Li-D co-deposition was measured as a function of substrate temperature, estimated to be in the range 200-428 C and distance between 25-85 mm to the plasma beam center. The D:Li ratio was determined via in-situ ion beam diagnostics (NRA and EBS) and the spectra analyzed simultaneously to maximise the precision of the measurement. The experimental results approach close to the theoretical maximum at 40:60 D:Li ratio and the thickness of the deposited films was 0.02 - 3.2 m. For witness plate temperatures above 400 C Li films under 150 nm in thickness were deposited and show lower D:Li ratios, as low as 5:95 D:Li ratio. At these temperatures the evaporation rate from the WPs is close to the deposition rate, and the decomposition pressure for LiD becomes comparable to the operational pressure in the vessel during the discharge. SOLPS-ITER simulations were also conducted to complement the experimental data. The results were used to narrow the range of CPS surface temperature to between ^{\circ} ^{+} ^{+} \%$, which matches well with the value determined from a quartz crystal microbalance. Due to limitations in the modeling of neutral interactions with Li coated surfaces, the SOLPS-ITER modeling does not well recreate the observed Li and D deposition layers on the WPs, indicating that this aspect of the modeling in Eirene needs improvement to accurately model plasmas containing significant quantities of Li. However, SOLPS-ITER simulations should be extended to include LiD molecules and improve the accuracy of heat flux towards the target to improve the comparison with experimental data.

Effects of size of an oxide layer on the surface properties of lithium irradiated by deuterium plasma

Atomic-Scale Direct Identification of Surface Variations in Cathode Oxides for Aqueous and Non-aqueous Lithium-Ion Batteries.

Study of Deuterium Retention on Lithiated Tungsten Exposed to High-Flux Deuterium Plasma Using Laser-Induced Breakdown Spectroscopy

Deuterium retention in co-deposition with lithium in Magnum-PSI: experimental analysis and comparison with SOLPS-ITER

Deuterium Retention Characteristics in Li Film by Coating and During Flowing Liquid Li Limiter Operation in Experimental Advanced Superconducting Tokamak

Influence of Li and B Coatings of Metal Walls on Deuterium Retention and Plasma Confinement in HT-7

Surface Diversifying and Deuterium Retention Characteristics of Doped Graphite with SiC Coating Exposed to Plasma Discharges in EAST Tokamak

Interfacial Effects On Lithium Superoxide Disproportionation In Li-O-2 Batteries

Retention Behavior Of Deuterium And Oxygen In Boronized Vps-W

Near-surface Bipartition Model for the Study of Material Response of Plasma-Facing Surfaces Exposed to Energetic Charged Particles

Influence of impurity gas seeding into deuterium plasma on the surface modification, sputtering erosion and deuterium retention in W and W-La2O3 alloy

Influences and Diffusion Effects of Lithium Contamination During the Thermal Oxidation Process of Silicon

Damage and Deuterium Retention in Lialo2 Single Crystals Irradiated with Deuterium Ions Using Ion-Beam Techniques and Optical Absorption Measurements

Dependence of deuterium retention and surface blistering on deuterium plasma exposure temperature and fluence in lanthanum oxide doped tungsten

Retention and recycling of deuterium in liquid lithium-tin slab studied by first-principles molecular dynamics

Electrodeposition of Tungsten Coatings and Deuterium Irradiation Behavior of Tungsten Coatings

Effect of Lithium Coating on Edge Particle Recycling in EAST H-mode Discharges

Sputtering Yield of Liquid Lithium Surface in the Deuterium Saturated State

Deuterium loading of redeposited-like W coatings present in tokamaks by ion implantation

Investigation of Wettability of Li on 316L SS Surface and Interfacial Interactions for Fusion Device

Investigations on Interactions Between the Flowing Liquid Lithium Limiter and Plasmas