Abstract:This study uses direct numerical simulation (DNS) data from two turbulent premixed flames to explore the variables involved in experimental measurement of the heat release rate, h. Several commonly used markers of h are compared, namely the CH, OH, and HCO radicals, as well as the spatial overlap of OH and CH2O and of H-atom and CH2O. The DNS data were also used to generate synthetic Planar Laser-Induced Fluorescence (PLIF) images that account for confounding experimental factors such as laser sheet thickness, optical blur, and shot noise. The overlap of OH and CH2O and the HCO radical appear to be the most promising markers of h, as they show excellent correlation with the high-intensity heat release. The synthetic-PLIF images show that increasing the laser sheet thickness and optical blur progressively de-correlates the measurement and the underlying DNS structures. However, for a sufficiently thin laser sheet (delta(sheet)/delta(L) less than or similar to 1), the correlation between the synthetic-PLIF and DNS remains strong even with significant-optical blur. Similar results are observed in the measured layer thickness and the peak-to-peak distance between the PLIF structure and the heat release layers. The resolution of h features was evaluated by measuring the average turbulent flame length, the spatial power spectral density, and the flame surface curvature. As the laser sheet thickness or optical blur is increased, the measured flame surface area progressively decreases, less fine-scale features are resolved, and regions of high curvature are eroded. Shot noise strongly affects spatial correlation with the DNS data and the layer thickness, but has relatively small impact on the turbulent flame length. Significantly greater deviations are observed for the overlap techniques requiring simultaneous measurement from two cameras, as optical blur and/or shot noise present in the two camera systems will both influence the resulting overlapped PLIF signal. (C) 2018 The Combustion Institute. Published by Elsevier Inc. All rights reserved.

Sub-Millimeter-Scale Measurement of Local Convective Heat Transfer Coefficient Exceeding 100 W/(m^2-K) Using an Optical Pump-Probe Method

A TEMPERATURE-GRADIENT CORRECTION METHOD FOR FILM COOLING EFFECTIVENESS MEASUREMENT USING ENDOSCOPE-BASED PSP TECHNIQUE

Assessment of Chemical Scalars for Heat Release Rate Measurement in Highly Turbulent Premixed Combustion Including Experimental Factors

Simultaneous Measurement of Thermal Conductivity and Heat Capacity Across Diverse Materials Using the Square-Pulsed Source (SPS) Technique

Measurement of Boiling Heat Transfer Coefficient in Liquid Nitrogen Bath by Inverse Heat Conduction Method

Measurement of the Thermal Transport Properties of Dielectric Thin Films Using the Micro-Raman Method

Robust methodology for determination of heat transfer coefficient distribution in convection

Analysis and Improvement of the Hot Disk Transient Plane Source Method for Low Thermal Conductivity Materials

Comprehensive Measurement of Three-Dimensional Thermal Conductivity Tensor Using a Beam-Offset Square-Pulsed Source (BO-SPS) Approach

A three-probe method for accurate nanoscale thermal transport measurements

Computational Assessment for Local and Total Heat Transfer Characteristics of Supercritical CO2 in Horizontal Heated Micro-Channel

A FEM-Based Inverse Calculation Method for Determination of Heat Transfer Coefficient in Liquid Quenching Process

Investigation and Optimization of the Hot Disk Method for Thermal Conductivity Measurements up to 750 °C

Frequency-domain probe beam deflection method for measurement of thermal conductivity of materials on micron length scale

Three-Dimensional Transient Heat Conduction Equation Solution for Accurate Quantification of Heat Transfer Coefficient in Transient Liquid Crystal Experiments

Measurement of High-temperature Thermophysical Properties of Bulk and Coatings Using Modulated Photothermal Radiometry

A New Noncontact Probe for Thermophysical Properties of Solid Surfaces

An Ultra-Fast TSP on a CNT Heating Layer for Unsteady Temperature and Heat Flux Measurements in Subsonic Flows

INVESTIGATION OF A QUASI-STEADY LIQUID CRYSTAL TECHNIQUE FOR FILM COOLING HEAT TRANSFER MEASUREMENTS

High-resolution wall temperature measurements with distributed fiber optic sensors

Local Heat Transfer Coefficient Measurements on Shaft Spray Cooled End Windings