Abstract:A rapid and reliable quench detection is vital for high current superconducting magnet system to prevent irreversible damage to a magnet by the quench phenomenon. The method for detecting the occurrence of a resistive transition has been widely adopted in the superconducting magnet. In the case of the voltage monitoring by means of dedicated taps, the electron quench detection device (EQDD) conversion unit, which converts detected high voltages into voltage-drop signal, should be required in the superconducting high field magnet. The power source of traditional quench detecting system, which can monitor for superconducting magnet with middle power operation, is supplied through the power transformer since the transformer can provide galvanic isolation between circuits. On the other hand, in the case of the super high magnet systems such as Korea Superconducting Tokamak Advanced Research and International Thermonuclear experimental reactor, since the maximum operation current and voltage of the super high field magnet keep over 60 kA and 50 kV DC, a passive component, which has strong an isolation device and high dielectric resistor qualities, has been required in the super high field magnet. If the power transformer is adopted in the super high field magnet, it can cause high cost for volume capacity since it needs for higher dielectric resistance value over 500 MΩ. Authors proposed the wireless resonance antenna and multi-receiver coils which can keep high level of dielectric resistance value with stability. As well as, the wireless power charging unit can reduce system volume due to multi-charging receivers for one antenna. In this study, authors investigated the effect of inserted resonator (Sx) coil between antenna and receiver coils, as well as, evaluated the electric field and magnetic field among the resonance coils under 300 W 370 kHz RF power generator since the strong electro-magnetic fields by the resonance coils can affect the electron devices inside of the EQDD module.

Performance Evaluation of an RFSoC Operating in a 1.25 Tesla Magnetic Field

Performance Evaluation of an RFSoC Operating in a 1.25 Tesla Magnetic Field

A Broadband NMR Magnetometer System with Field Searching and Automatic Tuning Function

Evaluating the RFSoC as a Software-Defined Radio readout system for Magnetic Microcalorimeters

A Low-Field Magnetic Resonance Signal Transmission and Reception Processing Platform

Development of a novel bunch oscillation recorder with RFSoC technology

rf breakdown with external magnetic fields in 201 and 805 MHz cavities

A Reconfigurable Platform for Magnetic Resonance Data Acquisition and Processing

RFSoC Gen3-Based Software-Defined Radio Characterization for the Readout System of Low-Temperature Bolometers

A DAQ Prototype for Front-end Waveform Digitization in Intensive Electromagnetic Field Circumstance

RFSoC-based front-end electronics for pulse detection

Development of a Real-Time Magnetic Field Measurement System for Synchrotron Control

Practical Investigations of Wireless Multiple-Power Charging Unit for Electron Quench Detection Device in the Super High Field Superconducting Magnet

Effect of Magnetic Field on Performance of SIS Mixers Measured at 385–500 GHz

rf Breakdown with and without External Magnetic Fields

An ultra-stable 1.5 tesla permanent magnet assembly for qubit experiments at cryogenic temperatures

A Study of Magnetic Shielding Performance of a Fermilab International Linear Collider Superconducting RF Cavity Cryomodule

High-Q operation of SRF cavities: The potential impact of thermocurrents on the RF surface resistance

Enabling Real-Time Impedance Measurements of Operational Superconducting Circuits of Accelerator Magnets