Abstract:Cobalt silicide (CoSi2) islands have been formed by the deposition of thin films (~0.1 to 0.3 nm) of cobalt on clean Si(111) and Si(100) substrates in ultrahigh vacuum (UHV) followed by annealing to ~880 degrees C. Conducting atomic force microscopy has been performed on these islands to characterize and measure their current-voltage (I-V) characteristics. Current-voltage curves were analyzed using thermionic emission theory to obtain the Schottky barrier heights and ideality factors between the silicide islands and the silicon substrates. Current-voltage measurements were performed ex situ for samples ("passivated surfaces") where the silicon surface surrounding the islands was passivated with a native oxide. Other samples ("clean surfaces") remained in UHV while I-V curves were recorded. By comparing barrier heights and ideality factors for islands on both surfaces, the effects of the non-passivated surfaces on conduction were studied. The clean surface barrier heights were found to be ~0.2 to 0.3 eV below barrier heights measured from similar islands on passivated surfaces. The reduced Schottky barrier is mainly attributed to Fermi level pinning by non-passivated surface states of the clean silicon surface. However, the measured barrier heights of the clean surface islands are equivalent on both Si(111) and Si(100), suggesting that the non-passivated surfaces are influenced by cobalt impurities. Furthermore, the barrier heights of islands on the clean surfaces are lower than due to Fermi level pinning alone and the additional barrier height lowering is primarily attributed to spreading resistance effects. Schottky barrier inhomogeneity may also cause additional barrier height lowering and non-ideality in the contacts. The clean surface barrier heights decreased and the ideality factors increased with decreasing temperature, which is attributed to the temperature variation of the Fermi level.

First-principles studies of Schottky barriers and tunneling properties at Al(111)/Si(111) and CoSi$_2$(111)/Si(111) interfaces

Interfacial charge transfer and Schottky barriers at c-Si/a-In heterojunctions

Character and Fabrication of Al/Al2O3/Al Tunnel Junctions for Qubit Application.

Superconducting qubits on silicon substrates for quantum device integration

First Principles Assessment of ZnTe and CdSe as Prospective Tunnel Barriers at the InAs/Al Interface

Josephson phase qubit circuit for the evaluation of advanced tunnel barrier materials

Observation of Interface Piezoelectricity in Superconducting Devices on Silicon

Conducting Atomic Force Microscopy Studies of Nanoscale Cobalt Silicide Schottky Barriers on Si(111) and Si(100)

Improving wafer-scale Josephson junction resistance variation in superconducting quantum coherent circuits

Macroscopic Quantum Tunneling and Qubit Design Parameters of Bi2Sr2CaCu2O8+δsurface Intrinsic Josephson Junctions

Using atom probe tomography to understand Schottky barrier height pinning at the ZnO:Al / SiO2 / Si interface

Influence of the stoichiometric ratio of barrier layer alumina on the transport properties of Josephson junctions

The influence of pinholes and weak-points in aluminium-oxide Josephson junctions

Quasiparticle tunneling as a probe of Josephson junction barrier and capacitor material in superconducting qubits

Mitigation of interfacial dielectric loss in aluminum-on-silicon superconducting qubits

Barrier height inhomogeneities of epitaxial CoSi2 Schottky contacts on n-Si (100) and (111)

Probing defect densities at the edges and inside Josephson junctions of superconducting qubits

Blurred interface induced control of electrical transport properties in Josephson junctions

Unveiling atomic structure and chemical composition of the Al/AlO x /Al Josephson junctions in qubits

Engineering Si-Qubit MOSFETs: A Phase-Field Modeling Approach Integrating Quantum-Electrostatics at Cryogenic Temperatures