Abstract:We characterize a novel instrument designed for radiation field decomposition and particle trajectory reconstruction for application in harsh radiation environments. The device consists of two Timepix3 assemblies with 500 μm thick silicon sensors in a face-to-face geometry. These detectors are interleaved with a set of neutron converters: 6 LiF for thermal neutrons, polyethylene (PE) for fast neutrons above 1 MeV, and PE with an additional aluminum recoil proton filter for neutrons above ∼4 MeV. Application of the coincidence and anticoincidence technique together with pattern recognition allows improved separation of charged and neutral particles, their discrimination against γ-rays and assessment of the overall directionality of the fast neutron field. The instrument's charged particle tracking and separation capabilities were studied at the Danish Center for Particle Therapy (DCPT), the Proton Synchrotron, and Super Proton Synchrotron with protons (50–240 MeV), pions (1–10 GeV/c and 180 GeV/c). After developing temporal and spatial coincidence assignment methodology, we determine the relative amount of coincident detections as a function of the impact angle, present the device's impact angle resolving power (both in coincidence and anticoicidence channels). The detector response to neutrons was studied at the Czech Metrology Institute (CMI), at n_ToF and the Los Alamos Neutron Science Center (LANSCE), covering the entire spectrum from thermal up to 600 MeV. The measured tracks were assigned to their corresponding neutron energy by application of the time of flight technique. We present the achieved neutron detection efficiency as a function of neutron kinetic energy and demonstrate how the ratio of events found below the different converters can be used to assess the hardness of the neutron spectrum. As an application, we determine the neutron content within a PMMA phantom just behind the Bragg-peak during clinical irradiation condition with protons of 160 MeV.

Considerations on time resolution of neutron irradiated single pixel 3D structures at fuences up to $10^{17}$ n$_{eq}$/cm$^{2}$ using 120 GeV SPS pion beams

Position resolution with 25 um pitch pixel sensors before and after irradiation

Evaluation of Planar Silicon Pixel Sensors with the RD53A Readout Chip for the Phase-2 Upgrade of the CMS Inner Tracker

Radiation hardness study on a CMOS pixel sensor for charged particle tracking

Evaluation of HPK $n^+$-$p$ planar pixel sensors for the CMS Phase-2 upgrade

Characterisation of 3D trench silicon pixel sensors irradiated at 1⋅1017 1 MeV neqcm-2

Development of n-in-p pixel modules for the ATLAS Upgrade at HL-LHC

A two-layer Timepix3 stack for improved charged particle tracking and radiation field decomposition

First Production of New Thin 3D Sensors for HL-LHC at FBK

Beam Test Studies of 3D Pixel Sensors Irradiated Non-Uniformly for the ATLAS Forward Physics Detector

Characterisation of novel thin n-in-p planar pixel modules for the ATLAS Inner Tracker upgrade

Front-End Design for SiPM-Based Monolithic Neutron Double Scatter Imagers

Signal height in silicon pixel detectors irradiated with pions and protons

Characterisation of a customised 4-chip Timepix3 module for charged-particle tracking

TCAD simulation of small-pitch 3D sensors for pixel detector upgrades at High Luminosity LHC

High-count-rate Particle Tracking in Proton and Carbon Radiotherapy with Timepix2 Operated in Ultra-Short Acquisition Time

Radiation Measurements Using Timepix3 with Silicon Sensor and Bare Chip in Proton Beams for FLASH Radiotherapy

Mighty Tracker -- Performance Studies of the MightyPix for LHCb

Digital Pixel Test Structures implemented in a 65 nm CMOS process

Charged particle detection performances of CMOS pixel sensors produced in a 0.18 um process with a high resistivity epitaxial layer

Electrical Characterization of 180 nm ATLASPix2 HV-CMOS Monolithic Prototypes for the High-Luminosity LHC