Abstract:Precise timing resolution is crucial for applications requiring photon time-of-flight (ToF) information such as ToF positron emission tomography (PET). Silicon photomultipliers (SiPM) for PET, with their high output capacitance, are known to require custom preamplifiers to optimize timing performance. In this paper, we describe simple alternative front-end electronics based on a commercial low-noise RF preamplifier and methods that have been implemented to achieve excellent timing resolution. Two radiation detectors with L(Y)SO scintillators coupled to Hamamatsu SiPMs (MPPC S10362-33-050C) and front-end electronics based on an RF amplifier (MAR-3SM+), typically used for wireless applications that require minimal additional circuitry, have been fabricated. These detectors were used to detect annihilation photons from a Ge-68 source and the output signals were subsequently digitized by a high speed oscilloscope for offline processing. A coincident resolving time (CRT) of 147 ± 3 ps FWHM and 186 ± 3 ps FWHM with 3 × 3 × 5 mm(3) and with 3 × 3 × 20 mm(3) LYSO crystal elements were measured, respectively. With smaller 2 × 2 × 3 mm(3) LSO crystals, a CRT of 125 ± 2 ps FWHM was achieved with slight improvement to 121 ± 3 ps at a lower temperature (15° C). Finally, with the 20 mm length crystals, a degradation of timing resolution was observed for annihilation photon interactions that occur close to the photosensor compared to shallow depth-of-interaction (DOI). We conclude that commercial RF amplifiers optimized for noise, besides their ease of use, can produce excellent timing resolution comparable to best reported values acquired with custom readout electronics. On the other hand, as timing performance degrades with increasing photon DOI, a head-on detector configuration will produce better CRT than a side-irradiated setup for longer crystals.

Performance studies of a SiPM-readout system with a pico-second timing chip

Performance studies of a SiPM-readout system with a pico-second timing chip

Study on Timing Performance of a Readout Circuit for SiPM

Monolithic MHz-frame rate digital SiPM-IC with sub-100 ps precision and 70$~μ$m pixel pitch

Preliminary Study on the Timing Characteristics of a Fast SiPM for the TOF of the Beam Line in IHEP

Monolithic MHz-frame rate digital SiPM-IC with sub-100 ps precision and 70 μm pixel pitch

Design considerations for a new generation of SiPMs with unprecedented timing resolution

Design and Performance Optimization of SiPM Array Multiplexing Readout Circuit

Optimizing time resolution and power consumption in a current-mode circuit for SiPMs

Improving the timing resolution of a time-of-flight and depth-of-interaction PET array detector

Multiple Time-over-threshold Readout Electronics for Fast Timing and Energy Resolving in a SiPM-based Positron Annihilation Lifetime Spectrometer

Investigation of Timing Resolution and Energy Resolution for SiPM/PET Detectors Using the Silicon Flexible Optical Material

Signal Processing for Pico-second Resolution Timing Measurements

Optimizing timing performance of silicon photomultiplier-based scintillation detectors

Evaluation of the Timing Performance of the DIET ASIC

A Novel Segmented SiPM Combined With Amplifiers on One Chip With Improved Single-Photon Timing Resolution in 0.35-μm CMOS

4D-tracking with digital SiPMs

Design and Performance of a High-Speed and Low-Noise Preamplifier for SiPM

A Fast Front-end Readout Design for NICA-MPD Shashlik Electromagnetic Calorimeter

Optimization of Dual Mode Readout of Sensl SiPM for TOF PET Detectors

DIET: a multi-channel SiPM readout ASIC for TOF-PET with individual energy and timing digitizer