Abstract:Silicon photomultiplier (SiPM) coupled scintillation detectors, are considered as promising tools for basic design of imaging instrumentation for the next generation PET, PET/MRI, SPECT and autoradiography scanners. The precise technical knowledge is inadequate, and still some challenges need to be addressed in order to successfully implement the SiPM technology in high resolution PET systems. Firstly, the advantages of SiPM pixel array 1 : 1 coupled crystal detector were obvious, and has minimized the position resolution errors of charge sharing in multiplexing circuits. However, in the system level, too many electronic channels have perplexed with complications, such as complex, messy electronics or dedicated ASIC chips. Multiplexing circuits were usually used to lower the complexity and cost of electronics, which has resulted in gradual deterioration of the performances of the detectors. Secondly, the light guide has become a necessity in high-resolution preclinical PET detectors. For a complete SiPM detector block, the light yield of outermost two rows/columns crystals were blurred due to the edge effects. In order to avoid this edge deterioration effect, crystal array size was reduced than that of the SiPM array in many PET detectors. The PET system built by these detectors had big gaps between the detector modules, which has largely affected the quality of reconstructed images. In order to solve these key problems, the Trans-PET basic detection module (BDM) II was designed and implemented in this study. This module was a flexible, easy to upgrade, simple, box geometry, small animal PET scanner. A better balance could be achieved by this detector, while reducing the electronic channels, and could simultaneously enhance the position resolution and time performance. A specially customized semi-cutting light guide had been designed, which could be optically multiplexed and diffused to optimize the effect of edge deterioration, so that both the outermost and inner crystals could be clearly distinguished. Specifically, in this PET module, two type crystal arrays with different crystal size had been designed, 13 x 13 crystal array with 1.89mm width and 18 x 18 crystal array with 1.2mm width, based on the same 6 x 6 SiPM array and frond-end electronics. The total area of 6 x 6 SiPM was 25.0 x 25.0mm(2), which was similar to Hamamatsu PSPMT R8900. The area of the SiPM array was slightly smaller than the size of the crystal array, in order to reduce the gap of the PET system built by this detector. The purpose of this study was to evaluate the performance of this detector module, including position profile quality, energy resolution, timing resolution in different operating environment. Based on this detector module, PET scanners can easily be designed with different shapes such as, quadrilaterals, hexagonals, octagonals, dodecagonals, twenty-four-sides, and other shapes.

Investigation of Timing Resolution and Energy Resolution for SiPM/PET Detectors Using the Silicon Flexible Optical Material

Characterization of Silicon Photomultipliers for PET Imaging

Optimization of Dual Mode Readout of Sensl SiPM for TOF PET Detectors

Study on Timing Performance of a Readout Circuit for SiPM

Advance in Silicon Photomultiplier for All-Digital Positron Emission Tomography

Improving the timing resolution of a time-of-flight and depth-of-interaction PET array detector

INVESTIGATION OF LSO SCINTILLATORS FOR HIGH-RESOLUTION PET DETECTORS

TOF and DOI Capable SiPM-PET Detector Using Striplines That Provide Row and Column Based Measurements

Effect of Crystal surface treatment on the timing response of a DOI detector for PET

Optimization of the SiPM Pixel Size for a Monolithic PET Detector

Progress in the Development of Silion Photomultipliers Electrophotonic Detector Based on Nuclear Medicine Imaging

Analog electro-optical readout of SiPMs achieves fast timing required for time-of-flight PET/MR

Optimizing timing performance of silicon photomultiplier-based scintillation detectors

DOI- and TOF-capable PET Array Detector Using Double-Ended Light Readout and Stripline-Based Row and Column Electronic Readout

On timing-optimized SiPMs for Cherenkov detection to boost low cost time-of-flight PET

Design And Initial Performance Evaluation Of A Novel Pet Detector Module Based On Compact Sipm Arrays

Design and Evaluation of LYSO/SiPM LIGHTENING PET Detector with DTI Sampling Method

Development of a SiPM-based PET imaging system for small animals

Time Performance Study of Plastic Scintillator Detector with SiPM Readouts

Low power implementation of high frequency SiPM readout for Cherenkov and scintillation detectors in TOF-PET

Design and measurement of Trans-PET basic detector module II using 6 x 6 SiPM array for small-animal PET