Abstract:Silicon photomultipliers (SiPM) are rapidly adapted in simultaneous time of flight (TOF) PET and MRI imaging system in recent years due to its fast timing response and immunity to magnetic field. The aim of this work is to develop multi-channel fast SiPM readout electronics for clinical TOF PET detector. The detector module is assembled by directly coupling a 12x12 LYSO crystal block to an 8x8 Sensl FB30035 SiPM array. We are developing two approaches of compact readout electronics to handle the large number of SiPM output channels. One is a low noise and high bandwidth, 128-channel ASIC to readout the 64 fast outputs and 64 standard outputs of the 8x8 SiPM array. The other approach is a conventional electronics based multiplexing readout scheme using discrete components. A charge division resistor network reduced 64 channels of standard output to four energy signals, and multiplexing and summing circuits reduced 64 channels of fast output to one timing signal, making the detector block highly compact and scalable. The ASIC design has been finished and it's ready for tape-out. Preliminary performance of the detector module readout by conventional electronics was evaluated. 12x12 LYSO crystals were well resolved and identified in the flood image and the average energy resolution was 15.6% +/- 1.3%. For single crystal pair, 240ps coincidence resolving timing (CRT) was achieved. It was dropped down to 500ps for detector block to single crystal configuration, due to the combination effects of: 1) degradation of fast signal rising edge by output capacitance addition of SiPMs and 2) large white electronic noise and ultrahigh dark count rate. The readout design will be further optimized by increasing the signal bandwidth and reducing noise to get better timing performance at a cost of increasing circuit complexity to a reasonable level. The performance of ASIC readout will be evaluated and good timing performance is expected due to the individual pixel timing pick-off.

Performance studies of a SiPM-readout system with a pico-second timing chip

Performance studies of a SiPM-readout system with a pico-second timing chip

Study on Timing Performance of a Readout Circuit for SiPM

Preliminary Study on the Timing Characteristics of a Fast SiPM for the TOF of the Beam Line in IHEP

Evaluation of the Timing Performance of the DIET ASIC

Monolithic MHz-frame rate digital SiPM-IC with sub-100 ps precision and 70$~μ$m pixel pitch

Monolithic MHz-frame rate digital SiPM-IC with sub-100 ps precision and 70 μm pixel pitch

Design considerations for a new generation of SiPMs with unprecedented timing resolution

Signal Processing for Pico-second Resolution Timing Measurements

Optimizing time resolution and power consumption in a current-mode circuit for SiPMs

Development of a Multi-Channel ASIC with Individual Energy and Timing Digitization for SiPM Detectors for TOF-PET Applications

DIET2: A SiPM Readout ASIC for 10 ps TOF-PET application

Timing resolution performance of Timepix4 bump-bonded assemblies

A Novel Segmented SiPM Combined With Amplifiers on One Chip With Improved Single-Photon Timing Resolution in 0.35-μm CMOS

Optimization of Dual Mode Readout of Sensl SiPM for TOF PET Detectors

A Fast Front-end Readout Design for NICA-MPD Shashlik Electromagnetic Calorimeter

Optimizing timing performance of silicon photomultiplier-based scintillation detectors

Front-end electronics development of large-area SiPM arrays for high-precision single-photon time measurement

4D-tracking with digital SiPMs

Design and Performance of a High-Speed and Low-Noise Preamplifier for SiPM

Development Of Multi-Channel Fast Sipm Readout Electronics For Clinical Tof Pet Detector