Abstract:Ultrahigh field systems (≥ 7 T) can increase the signal-to-noise ratio of magnetic resonance imaging (MRI), improving imaging performance compared to systems with lower fields. However, these enhancements heavily rely on a high B0 magnetic field homogeneity level, which can be achieved through superconducting shimming. This paper presents a novel two-stage superconducting shimming method designed to achieve precise shimming for a 7 T MRI superconducting magnet. In the initial stage, detailed measurements and fittings were conducted to determine the current polarity and the axial or circumferential positions of the shim fields. Subsequently, an optimization strategy was implemented to determine the optimal shim currents with a flexible target field. The second stage involves an iterative process to fine-tune the current of a specific shim coil, identified as having the most significant impact on field homogeneity. The overall fitness of 99.5% underscores the precision in determining the current polarity and position of the shim fields. Significantly, the calibrated shim system substantially improves the peak-to-peak and Root Mean Square Error (RMSE) field homogeneities from 107.42 ppm and 37.00 ppm to 11.12 ppm and 3.26 ppm, respectively, representing improvements of 89.65% and 91.19%. Furthermore, the simulation results of the fine-tuning stage demonstrate additional enhancements in peak-to-peak field homogeneity, to 9.9 ppm by reducing the current of the Z2 shim coil by 51.3 mA. Additionally, the shimmed magnetic field exhibited high time stability, with a maximum variation of only 27 µT observed within 48 h. Thus, the proposed two-stage superconducting shimming framework effectively addresses the challenge of imperfect B0 magnetic fields, enhancing peak-to-peak and RMSE field homogeneity. The stepwise optimized approach also mitigates deviations caused by shim-to-shim coupling, demonstrating its efficacy in achieving precise shimming in ultrahigh-field MRI systems.

AC Loss Measurement in Nb3Sn Coil for a New Fast Switching-field MR Concept Magnet

A Broadband NMR Magnetometer System with Field Searching and Automatic Tuning Function

Low Field NMR System Based on High T_c DC-SQUID

Development of High Magnetic Field Magnet Technologies for the Magnetic Resonance Medical Imaging

Superconducting and low temperature RF Coils for Ultra-Low-Field MRI: A Study on SNR Performance

Superconducting Joint and Persistent Current Switch for a 7-T Animal MRI Magnet

Suppression of flux jumps in high-$J_c$ Nb$_3$Sn conductors by ferromagnetic layer

A Non-Steady State NMR Effect Based Time-Varying Magnetic Field Measurement Method and Experimental Apparatus

Nonlinear Near-Field Microwave Microscope For RF Defect Localization in Superconductors

Thermal Analysis of Persistent Current Switch for Magnetic Resonance Imaging Superconducting Magnet

First-Cut Design of a Benchtop Cryogen-Free 23.5-T/25-mm Magnet for 1-GHz Microcoil NMR

Experiment and Numerical Modeling of Current Distributions Inside REBCO Tapes of No-Insulation Superconducting Magnet Coils Under Time-Varying Fields

Study on demagnetization behaviour of no-insulation (NI) persistent-current mode (PCM) HTS coil under external AC fields by 3D FEM simulation

Design, Fabrication and Measurement of a 3 T Cryogen-Free Animal MRI Superconducting Magnet

The sub-millimetre non-uniformity measurement of residual and coil-generated field in the magnetic shield using atomic vapor cell

Multimodal surface coils for low-field MR imaging

Rotatable Small Permanent Magnet Array for Ultra-Low Field Nuclear Magnetic Resonance Instrumentation: A Concept Study

Multimodal surface coils for low field MR imaging

Direct current magnetic Hall probe technique for measurement of field penetration in thin film superconductors for superconducting radio frequency resonators

Implementing a Two-Stage, Shim Field-Calibrated Superconducting Shimming Method on a 7t Cryogen-Free Small Animal MRI Magnet

Non-Steady State NMR Effect and Application on Time-Varying Magnetic Field Measurement