Abstract:A superconducting magnet, which operates in a persistent current mode (PCM), is able to reduce heat loss on current leads, therefore, gradually become promising and important in many industrial usages. To realize the PCM, a persistent current switch (PCS) is an indispensable part, which also greatly influences final charging quality, and PCS has been designed extending to many kinds. In this paper, another kind of PCS is proposed, which is made by a section of tape in a coil. The PCS is triggered by overcurrent directly from the current source without any additional switching triggers. Performance of the PCS in two different winding conditions (i.e., in an insulated (INS) coil and a no-insulation (NI) coil) are tested. Each coil tails is soldered together as a joint to form a closed current loop. Thus, four experimental cases can be investigated with regards to the four conditions: INS or NI coil with the section (i.e., the PCS) selected including the joint, which is used to form a closed loop or not. Results show that in certain conditions, 95% of source current ultimately flows into the coil, and the PCS is switched off at an optimal threshold value of successfully charging the coil and generating the least heat. Besides, the absence of additional switching triggers can reduce the weight and size of the magnet. Meanwhile, four equivalent electrical circuit models corresponding to the four experimental cases are established and verified.

Thermal Analysis of Persistent Current Switch for Magnetic Resonance Imaging Superconducting Magnet

Performance Test of Superconducting Switch for Nmr Magnet

Thermal Analysis of a Head-Only 1.5 T Magnetic Resonance Imaging Superconducting Magnet

A Pulsed Current Charging Mechanism for High Temperature Superconducting Magnets

Superconducting Joint and Persistent Current Switch for a 7-T Animal MRI Magnet

Research summary of superconducting switch

A Superconducting Magnet System for Whole-Body Metabolism Imaging

Quench Protection Design of a Head-Only 1.5 T MRI Superconducting Magnet

Thermal Analysis of the 4 K Cryostat Within a 1.5 T Conduction-Cooled Superconducting Magnet for Whole-body MRI Application

Conduction-Cooled Superconducting Magnet with Persistent Current Switch for Gyrotron Application

An Overcurrent Controlled HTS Persistent Current Switch Without Any Additional Switching Triggers

Thermal analysis of conduction-cooled superconducting magnet system based on ANSYS

A superconducting switch using induced current in the closed loop circuit

Protection Circuit and Quench Simulation of a 7 T Superconducting Magnet for Animal MRI

Stability Analysis for Cryocooled Aluminum-Stabilized Superconducting Magnet

Stress Analysis of a 7 T Actively Shielded Superconducting Magnet for Animal MRI

Thermally Assisted Magnetic Switching of A Single Perpendicularly Magnetized Layer Induced by an In-Plane Current

Practical Application of Gas-Gap Thermal Switch in Conduction Cooled Superconducting Magnet System

Quench Protection Design of a 1.5 T Superconducting MRI Magnet

Preliminary Mechanical Analysis of a 9.4-T Whole-Body MRI Magnet

RETRACTED: Development of a Cryogenic Test Bed for High Amperage Critical Current Measurement on High Temperature Superconductor Wire