Abstract:Multi-layer crystallization and uncontrollable defects were the main factors that limiting the quality of Cu 2 ZnSn(S,Se) 4 (CZTSSe) films. Here a hybrid crystallization strategy was proposed to simultaneously improve the morphology and defect properties of CZTSSe film. Firstly, we found the variation of the microstructures (constitution, chemical environment of the elements, etc.) in precursor films can greatly alter the grain-growths of CZTSSe films. Detailed characterizations revealed that the chemical environment of S in the precursor film may influence the S-to-Se substitution of the film during the selenization process. This can further affect the grain-growth mechanism and the properties of CZTSSe film. While the S-to-Se substitution of the film mainly occurred below 500°C, the NaSe x on the surface of the film could dominate the grain-growth (Na-mechanism). For this mechanism, the CZTSSe film exhibited bi-layer morphology and relatively high band-tail energy, but shallow-acceptor was detected in the film. The solar cells based on the CZTSSe films reached the efficiency of 10.6%. As a comparison, liquid phase could be generated when the S-to-Se substitution of the film shifted to higher temperature (>500°C). In this condition, the grain-growth would be dominated by the liquid phase (LP-mechanism). Such mechanism can eliminate the multi-layer crystallization and reduce the band-tail energy, but the surface properties of the CZTSSe film was deteriorated and the formation of shallow-acceptor in CZTSSe was inhibited. The fabricated solar cells achieved the efficiency of 10.3%. Based on the results above, a bi-layer precursor film contained sub-layers with different microstructures was proposed to regulate the crystallization of CZTSSe. The co-existence of different microstructures in the precursor film could induce a hybrid grain-growth mechanism for the CZTSSe film (e.g., the Na-mechanism worked on the surface while the LP-mechanism worked in the bottom simultaneously). Such grain-growth mechanism can yield CZTSSe film with uniform morphology and favorable defect properties. The CZTSSe solar cells based on the hybrid grain-growth mechanism achieved the best efficiency of 12.6%. The investigation in this paper would provide new solutions for the crystallization regulation on CZTSSe photovoltaic material.

Ultrasonication‐Assisted Seed Screening Enables Oriented and Efficient Low‐Dimensional Crystal‐Structural Thin‐Film Photovoltaics

Standing 1D Chains Enable Efficient Wide‐Bandgap Selenium Solar Cells

Crystalline Liquid-like Behavior: Surface-Induced Secondary Grain Growth of Photovoltaic Perovskite Thin Film

Crystallographic Orientation Control of 1D Sb 2 Se 3 Nanorod Arrays for Photovoltaic Application by In Situ Back‐Contact Engineering

Single Crystalline GeSe Van Der Waals Ribbons With Uniform Layer Stacking, High Carrier Mobility, and Adjustable Edge Morphology

GeSe Thin-Film Solar Cells Fabricated by Self-Regulated Rapid Thermal Sublimation

Enhanced performance of GeSe thin-film solar cells via bifacial charge transport materials design

Unveiling Crystal Orientation in Quasi‐2D Perovskite Films by In Situ GIWAXS for High‐Performance Photovoltaics

Unveiling the Role of Ge in CZTSSe Solar Cells by Advanced Micro‐To‐Atom Scale Characterizations

Solution‐Processed Sb2(S, Se)3 Seeds‐Assisted Sb2Se3 Thin Film Growth for High Efficiency Solar Cell

Organic Heteroepitaxy Growth of High-Performance Responsive Thin Films with Solution Shearing Crystals as Templates

Optimized grain growth for efficient solution-processed Bi-doped Cu2ZnSn(S,Se)4 thin film solar cells via spin-coated layers adjustment and two-step selenization

A General Vapor‐Induced Coating Approach for Layer‐controlled Organic Single Crystals

Interfacial Strain Engineering in Wide-Bandgap GeS Thin Films for Photovoltaics

In situ growth of a 2D/3D mixed perovskite interface layer by seed-mediated and solvent-assisted Ostwald ripening for stable and efficient photovoltaics

Fast Growth of Thin MAPbI3 Crystal Wafers on Aqueous Solution Surface for Efficient Lateral‐Structure Perovskite Solar Cells

Enhanced charge carrier transport via efficient grain conduction mode for Sb2Se3 solar cell applications

Regulating the crystal orientation of vapor-transport-deposited GeSe thin films by a post-annealing treatment

: a promising approach for next generation thin fi lm photovoltaics

Simultaneously improving the morphology and defect properties of CZTSSe film via hybrid grain-growth mechanism

New Two-Dimensional Ge-Sb-Te Semiconductors with High Photovoltaic Performance for Solar Energy Conversion