Abstract:LaBr3:Ce crystals have good scintillation properties for X-ray spectroscopy. Initially, they were introduced for radiation imaging in medical physics with either a photomultiplier or SiPM readout, and they found extensive applications in homeland security and gamma-ray astronomy. We used 1 inch round LaBr3:Ce crystals to realize compact detectors with the SiPM array readout. The aim was a good energy resolution and a fast time response to detect low-energy X-rays around 100 keV. A natural application was found inside the FAMU experiment, at RIKEN RAL. Its aim is a precise measurement of the proton Zemach radius with impinging muons, to contribute to the solution to the so-called proton radius puzzle. Signals to be detected are characteristic X-rays around 130 KeV. A limit for this type of detector, as compared to the ones with a photomultiplier readout, is its poorer timing characteristics due to the large capacity of the SiPM arrays used. In particular, long signal falltimes are a problem in experiments such as FAMU, where a prompt background component must be separated from a delayed one (after 600 ns) in the signal X-rays to be detected. Dedicated studies were pursued to improve the timing characteristics of the used detectors, starting from hybrid ganging of SiPM cells; then developing a suitable zero pole circuit with a parallel ganging, where an increased overvoltage for the SiPM array was used to compensate for the signal decrease; and finally designing ad hoc electronics to split the 1 inch detector SiPM array into four quadrants, thus reducing the involved capacitances. The aim was to improve the detectors timing characteristics, especially falltime, while keeping a good FWHM energy resolution for low-energy X-ray detection.

One inch LaBr3:Ce detectors, with temperature control and improved time resolution for low energy X-rays spectroscopy

Improving the Time Resolution of Large-Area LaBr3:Ce Detectors with SiPM Array Readout

Online control of the gain drift with temperature of SiPM arrays used for the readout of LaB$_3$:Ce crystals

Characterization of Large Volume 3.5 x 8 inches LaBr3:Ce Detectors

FAST TIMING: LIFETIME MEASUREMENTS WITH LaBr3(Ce) SCINTILLATORS

A Large Area LaBr3/NaI Phoswich for Hard X-ray Astronomy

Localisation of gamma-ray interaction points in thick monolithic CeBr3 and LaBr3:Ce scintillators

Characteristics and Time Resolutions of Two CeBr3 Gamma-Ray Spectrometers

A Prototype of LaBr3:Ce in situ Gamma-Ray Spectrometer for Marine Environmental Monitoring

Study on the scintillation performance of CLLB:Ce scintillator and optimization of measurement method

Performance tests of a large volume cerium tribromide (CeBr3) scintillation detector

Development of a 3” LaBr3 SiPM-Based Detection Module for High Resolution Gamma Ray Spectroscopy and Imaging

Quantitative Analysis and Efficiency Study of PSD Methods for a LaBr3:Ce Detector

Positron Annihilation Life Spectrometer with LaCl 3 :Ce 3+ Scintillator Crystal

Response of LaBr3:Ce Scintillation Detector Itself to Fast Neutrons

The Intrinsic Energy Resolution of LaBr$_3$(Ce) Crystal for GECAM

Yap:Ce And Csi(Tl) Detectors For Dielectronic Recombination Experiment At The Csrm

Performance comparison of four compact room-temperature detectors-two cadmium zinc telluride (CZT) semiconductor detectors, a LaCl/sub 3/(Ce) scintillator, and an NaI(Tl) scintillator

Response of G-NUMEN LaBr$_3$(Ce) detectors to high counting rates

ECFA Detector R&D Panel, Review Report

Comparative Characterization Study of a LaBr3(Ce) Scintillation Crystal in Two Surface Wrapping Scenarios: Absorptive and Reflective