Non-chiral one-dimensional states propagating inside AB/BA domain walls in bilayer graphene

V.V. Enaldiev,C. Moulsdale,A.K. Geim,V.I. Fal'ko
DOI: https://doi.org/10.20935/AcadNano7267
2024-10-25
Abstract:Boundaries between structural twins of bilayer graphene (so-called AB/BA domain walls) are often discussed in terms of the formation of topologically protected valley-polarised chiral states. Here, we show that, depending on the width of the AB/BA boundary, the latter can also support non-chiral one-dimensional (1D) states that are confined to the domain wall at low energies and take the form of quasi-bound states at higher energies, where the 1D bands cross into the two-dimensional spectral continuum. We present the results of modeling of electronic properties of AB/BA domain walls with and without magnetic field as a function of their width and interlayer bias.
Mesoscale and Nanoscale Physics
What problem does this paper attempt to address?
The problems that this paper attempts to solve are: **In the AB/BA domain walls of bilayer graphene (BLG), whether there are non - chiral one - dimensional (1D) electron states exists, and to study the properties of these states and their influence on experiments**. Specifically, the paper explores the following issues: 1. **Existence conditions of non - chiral 1D states**: - Through theoretical modeling and numerical simulation, the authors studied the influence of the AB/BA domain wall width and the inter - layer bias voltage on the electron states. - The results show that non - chiral 1D electron states can exist at specific domain wall widths and low energies. These states will become quasi - bound states at high energies and enter the two - dimensional spectral continuum. 2. **Differences from existing chiral states**: - The AB/BA domain walls in bilayer graphene are usually considered to support topologically protected chiral valley - polarized states. However, this paper points out that non - chiral 1D states can also exist in these domain walls. - These non - chiral states can propagate bidirectionally in each valley, thus exhibiting physical properties different from those of chiral states. 3. **Behavior under a magnetic field**: - The study also explored how non - chiral 1D states interact with Landau levels when a perpendicular magnetic field is applied. The results show that the characteristics of these quasi - bound states can be traced by observing the dispersion relation of Landau levels. 4. **Possibility of experimental verification**: - The paper discussed the potential manifestations of these non - chiral 1D states in experiments, especially the possible observable phenomena in electrical transport measurements. For example, within certain parameter ranges, these states may lead to additional conductive channels, thereby changing the conductance of the device. ### Key formulas - **Description of domain wall width**: \[ u_y(x)=\frac{2a}{\sqrt{3}\pi}\arctan\left(e^{2x / w}\right) \] where \(w = \frac{a}{\pi}\sqrt{\frac{\mu}{6V}}\) describes the full width of the domain wall. - **Hamiltonian**: \[ H_\xi(r_0)=\begin{pmatrix} v\sigma_\xi p+\frac{\Delta}{2}&T_\xi(r_0)\\ T^\dagger_\xi(r_0)&v\sigma_\xi p-\frac{\Delta}{2} \end{pmatrix} \] where \(T_\xi(r_0)\) is the tunneling matrix, \(r_0(x)=\left(0,a\sqrt{3}+u_y(x)\right)\). - **Effect of Landau levels**: The magnetic field is introduced through Peierls substitution: \[ p\rightarrow\left(-i\hbar\partial_x,-i\hbar\partial_y - eBx\right) \] In summary, this paper aims to reveal and describe in detail the non - chiral 1D states existing in the AB/BA domain walls of bilayer graphene, and to explore their physical behaviors under different conditions and the possibility of experimental observation.