Abstract:We demonstrate an interferometric piezoresponse force microscopy (PFM) method for quantifying the full, three-dimensional response of piezoelectric material without requiring sample rotation. We show that this approach yields quantitative 3D measurement independent of the sample orientation beneath the tip. This approach simplifies existing, angle-resolved PFM techniques, since it only requires four measurements (or three with less redundancy and error checking) to map the full three dimensional, time independent strain field. It also does not require rotating the sample with respect to the cantilever. It benefits from the greatly reduced noise floor of our laser doppler vibrometer interferometric displacement sensor (IDS) of 50fm per rootHz or our quadrature phase differential interferometer (QPDI) noise floor of 5fm per rootHz and the intrinsic accuracy of interferometric measurements. One important result is that the in-plane piezo sensitivities were systematically smaller than the vertical by a factor of 2 to 3. A simple analysis of vertical and lateral contact stiffnesses, due to the difference in the Young (vertical) and Shear (lateral) sample moduli predicts a factor of 2.5, in good agreement with the measurements. Finally, we fit observed OBD measurements to a linear combination of interferometrically measured in-plane and vertical responses for four different ferroelectric samples. We found that the in-plane response accounted for 20% or more of the OBD response and surprisingly, in two out of the four samples, the in-plane contribution was in fact 2x larger than the vertical.

Measurement of piezoelectric transformer vibrations by digital holography

Axial nanodisplacement measurement based on the double-helix point spread function generated using radially polarized beams with vortex phase modulation

A High-Resolution Displacement Sensor Based on a Grating Interferometer with the Phase Modulation Technique

Low Noisy Dual Wavelength Digital Holography and Application in the Ultra-precision Machining Surface Measurement

DIGITAL HOLOGRAPHIC PIV FOR 3D FLOW MEASUREMENT

The Modeling of a Piezoelectric Transformer Using a Transverse Vibration

Analysis and Measurement of the Vibrations of Multilayer Piezoelectric Transformer

Micro-vibration measuring technology based on heterodyne interference

Position sensitive detector based non-contact vibration measurement with laser triangulation method utilizing Gabor Transform for noise reduction

Disc piezoelectric ceramic transformers

Applications of Laser Holography in Vibratory Analysis of Piezoelectric Ceramics and Transducers

A Circuit Design in Piezoelectric Vibration Measurement System

Dynamic phase microscopy: measurements of translational displacements at sub-nanometer scale

10-pm-order mechanical displacement measurements using heterodyne interferometry.

Application of Electronic Speckle Pattern Shearing Interferometry with High-Speed Camera in Vibration Analysis of Piezoelectric Transducer

Note: an in Situ Method for Measuring the Non-Linear Response of a Fabry-Perot Cavity.

Accurate 3D Nanoscale Electromechanical Imaging with a Metrological Atomic Force Microscope

Measurement of in-plane and out-of-plane displacements and strains using digital holographic moiré

Experimental Study Of Vibration Measurement Based On Laser Frequency Splitting Principle

Phase-sensitive narrowband heterodyne holography