Torsional Vibration Analysis of Pre-Twist Cantilever Beam Using FEM

P. Prasad,N. Kishore
Abstract:Structures having the shape of blades are often found in several practical engineering examples such as turbines and aircraft rotary wings. For reliable and economic designs of the structures, it is necessary to estimate the modal characteristics of those structures accurately. To design these components, the dynamic characteristic, especially near resonant condition, need to be well examined to assure a safe operation. Among the dynamic characteristics of these structures, determining the natural frequencies and associated mode shapes are of fundamental importance in the study of resonant responses. An accurate prediction of the forced response is usually very difficult because of the uncertainty of the excitation. A single free standing blade can be considered as a pretwisted cantilever beam with a rectangular cross-section. The torsional vibration of pre twist cantilever beam of rectangular cross section is done so that this resembles to a blade. The differential equation for the torsional vibration of pre-twisted cantilever beam of rectangular cross section has been obtained. The beam is considered as Timoshenko beam instead of Euler-Bernoulli Beam or Rayleigh Beam because it will consider shear correction factor, rotary inertia, warping constant. The Galerkin’s method is used to obtain the frequencies of various modes of vibration. This is again solved by fem software ANSYS and their results are compared. Introduction The torsional vibration of a rotating structure can occur in many engineering applications such as turbomachinery blades, slewing robot arms, aircraft propellers, helicopter rotors, and spinning spacecraft. To design these components, the dynamic characteristic, especially near resonant condition, need to be well examined to assure a safe operation. Among the dynamic characteristics of these structures, determining the natural frequencies and associated mode shapes are of fundamental importance in the study of resonant responses. It is very important for manufacturers of turbo machinery components to know the natural frequencies of the rotor blades, because they have to make sure that the turbine on which the blade is to be mounted does not have some of the same natural frequencies as the rotor blade. Otherwise, a resonance may occur in the whole structure of the turbine, leading to undammed vibrations, which may eventually wreck the whole turbine. An accurate prediction of the forced response is usually very difficult because of the uncertainty of the excitation. Moreover, under the resonance conditions, what limits the vibration amplitude is the amount of damping available. In most cases, the damping is almost entirely aerodynamic and its assessment is just as uncertain as the excitation. Thus, classic design practice for such structures has been mainly to rely on the knowledge of the natural frequencies to avoid anticipated resonances.
Engineering
What problem does this paper attempt to address?