Abstract:High-power Er and Er/Yb co-doped fiber laser systems, operating at 1550 nm are attractive for many practical applications. At present, the most efforts of the laser developers are focused on the production of such lasers either with ultrashort (fs) or ns pulse duration. For the ns operation, master oscillator power amplifier (MOPA) design is commonly used, where the master oscillator is semiconductor DFB or DBR laser. It allows on the fly electronically configurable design of the laser, with adjustable repetition rate and pulse duration. Such concept cannot be applied if μs pulse-width is required, especially at low repetition rate due to several reasons, where the main are: pulse steepening during the amplification, and significand amplified spontaneous emission (ASE) growth. Pulsed pumping, is a common solution to avoid ASE at low repetition rate for the ns or fs laser sources. However, for the μs laser it does not solve the problem of pulse steepening, which decreases the pulse duration from μs range to almost ns, and, due to specific Er-Yb band configuration, at reasonable pump level the inversion population increases slowly, reaching the maximum nearly 150 - 300 μs after the pump starts. It makes impossible to create homogeneous rectangular-shape μs pulses. In our work, all these features were analyzed by performing numerical simulation, based on the model described in [1].

83 W, 3.1 MHz, square-shaped, 1 ns-pulsed all-fiber-integrated laser for micromachining

Femtosecond Mode-locked Fiber Laser at 1 Μm Via Optical Microfiber Dispersion Management

μS Pulsed, Low Repetition Rate, 30 W Fiber Laser at 1550 nm

High-energy 100-ns single-frequency all-fiber laser at 1064 nm

Nanosecond Square Pulse Fiber Laser Based on the Nonlinear Amplifying Loop Mirror

High-peak-power, single-frequency, single-mode, linearly polarized, nanosecond all-fiber laser based on self-phase modulation compensation

Generation of sub-30 fs pulses from an erbium-doped fiber amplifier at 203 MHz repetition rate

3 GHz, Yb-fiber laser-based, few-cycle ultrafast source at the Ti:sapphire laser wavelength

97-Watt, 1.08-Gigahertz Repetition Rate, Femtosecond Yb:fiber Laser Source

High-energy single-frequency pulsed fiber MOPA at 1064 nm based on a hybrid active-fiber

165 MHz highly stable femtosecond Er:ZBLAN fiber laser operating at 2.8 µm

140 kHz, 1.2 ps pulses from an all-PM Yb-doped fiber master oscillator-power amplifier

High Energy and High Power Single Frequency 1572 nm Laser With an All-Fiber MOPA

High Energy, Monolithic Fiber Femtosecond Lasers

Ultra Compact Kilohertz-Linewidth High-Power Single-Frequency Laser Based on Er3+/Yb3+-Codoped Phosphate Fiber Amplifier

PCF Based High Power Narrow Line Width Pulsed Fiber Laser

High-Power GHz Burst-Mode All-Fiber Laser System with Sub 300 fs Pulse Duration

Investigations of the High-Power, Single-Frequency, Sub-Microseconds, 1548-nm Fiber Laser Based on the Optical Pulse Modulation

11-mJ pulse energy wideband Yb-doped fiber laser

An All Fiber 1.94 Μm Nanosecond Pulse Laser Amplified by Highly Tm 3+ -Doped Silicon Fibers

All-polarization-maintaining, semiconductor saturable absorbing mirror mode-locked femtosecond Er-doped fiber laser with a gigahertz fundamental repetition rate