Abstract:We explore the possibility of using free (as opposed to driven) oscillations to verify wire tension in large, open-frame multiwire planes. Using finite-element simulation we predict the signal when two wires are set in motion by applying and holding a DC voltage between them (electrostatic excitation). The resulting current signal is marginal. However, the program relates voltage, oscillation amplitude and signal, and it is easy to get enough amplitude (of order microns) by gently tapping the wire frame. We perform an end-to-end experimental test. Four 1.5m wires, at various tensions around 5N, are mounted in an aluminum channel. They are connected to a low-noise, balanced current-to-voltage preamp designed for good common-mode rejection. The 150V bias, from 9V batteries in series, is built into the preamp. Data are taken with a Tektronix 1202B scope, stored on a USB flash drive, and transferred to a laptop computer for analysis. Ten measurements, each with 2500 samples spanning 1s, are taken for each of the three wire pairs. The wires are excited by tapping the frame with a small mallet. Because the wire tensions are different, the waveforms exhibit beats. The data are analyzed by a program which decomposes the waveform step by step to extract the base and beat frequencies and thereby, two resonant frequencies per wire pair. Finally, those frequencies are disambiguated to obtain the frequency for each wire, which is then converted to a tension. The four tensions are then found mechanically by measuring the g/mm required to deflect each wire at its midpoint. The two values of tension agree well. We conclude that the method verifies tension to approximately 2% (1 sigma) in a little over 1s for 1.5m wires, and would be faster for shorter wires.

Measuring the length of stretched wires with a avalanche oscillator

Rapid measurement of tension in multi-wire arrays using free damped oscillations

A Bridged Contactless Measurement Technique for LC Tank Based Voltage-Controlled Oscillator.

Experimental analysis of wide-spectrum oscillator with nonmatched transmission line

An Optoelectronic Oscillator‐based Strain Sensor with Extended Measurement Range

The measuring systems of the wire tension for the MEG II Drift Chamber by means of the resonant frequency technique

Wire array experiments in a low impedance and low current generator

Simple acoustical technique for automated measurement of drift tube anode wire tension

Self‐Actuation: Liquid Metal Machine Triggered Violin‐Like Wire Oscillator (adv. Sci. 10/2016)

Vibrating wires for beam diagnostics

Polymer Wire Chemical Sensor Using a Microfabricated Tuning Fork

Liquid Metal Machine Triggered Violin‐Like Wire Oscillator

A novel method to measure the high-frequency properties of nanomaterials

Archimedean Spiral Pairs with no Electrical Connections as a Passive Wireless Implantable Sensor

Eight-fold Signal Amplification of a Superconducting Nanowire Single-Photon Detector Using a Multiple-Avalanche Architecture.

Oscillator interrogated time-of-flight optical fiber interferometer for global strain measurements

A Superstretchable and Ultrastable Liquid Metal–Elastomer Wire for Soft Electronic Devices

Two-Volt Josephson Arbitrary Waveform Synthesizer Using Wilkinson Dividers

A superconductive undulator with period length of 3.8 mm

Pulsed-Mode Magnetic Field Measurements with a Single Stretched Wire System