Abstract:The development of a new hard x-ray beamline I-TOMCAT equipped with a 1-meter-long short-period bulk high-temperature superconductor undulator (BHTSU) has been scheduled for the upgrade of the Swiss Light Source (SLS 2.0) at the Paul Scherrer Institute (PSI). The very hard x-ray source generated by the BHTSU will increase the brilliance at the beamline by over one order of magnitude in comparison to other state-of-the-art undulator technologies and allow experiments to be carried out with photon energies in excess of 60 keV. One of the key challenges for designing a 1-meter-long (100 periods) BHTSU is the large-scale simulation of the magnetization currents inside 200 staggered-array bulk superconductors. A feasible approach to simplify the electromagnetic model is to retain five periods from both ends of the 1-meter-long BHTSU, reducing the number of degrees of freedom (DOFs) to the scale of millions. In this paper, the theory of the recently-proposed 2D A-V formulation-based backward computation method is extended to calculate the critical state magnetization currents in the ten-period staggered-array BHTSU in 3D. The simulation results of the magnetization currents and the associated undulator field along the electron beam axis are compared with the well-known 3D H-formulation and the highly efficient 3D H-{\phi} formulation method, all methods showing excellent agreement with each other as well as with experimental results. The mixed H-{\phi} formulation avoids computing the eddy currents in the air subdomain and is significantly faster than the full H-formulation method, but is slower in comparison to the A-V formulation-based backward computation. Finally, the fastest and the most efficient A-V formulation in ANSYS 2020R1 Academic is adopted to optimize the integrals of the undulator field along the electron beam axis by optimizing the sizes of the end bulks.

A superconductive undulator with period length of 3.8 mm

Fully-staggered-array bulk Re-Ba-Cu-O short-period undulator: large-scale 3D electromagnetic modelling and design optimization using A-V and H-formulation methods

The Construction of A 9-Pole Prototype for Srrc U-10 Undulator

HTS Undulator Design Study and First Results

A New Type of Linear Periodic Magnets

Experimental Verification of a Permanent Undulator for a Strong Helical Field

Short-period High-Strength Helical Undulator by Laser-Driven Bifilar Capacitor Coil.

Preliminary Measurements for a Sub-Femtosecond Electron Bunch Length Diagnostic

Differential method for measuring periodic magnetic structure

Tapered helical undulator system for high efficiency energy extraction from a high brightness electron beam

Design, construction, and magnetic field characterization of a Segmented Adaptive-Gap In-Vacuum Undulator prototype for NSLS-II

Development and Operation of a Pr2Fe14B Based Cryogenic Permanent Magnet Undulator for a High Spatial Resolution X-ray Beamline

Development of a Quasi-Periodic Undulator for the HLS

3D Modeling of High Temperature Superconducting Staggered Array Undulator

The Online Undulator Magnetic Field Measurement System

Superstructures For High Current Fel Application

Preliminary Study of EEHG-based Superradiant Undulator Radiation at the HLS-II Storage Ring

Status of non-destructive bunch length measurement based on coherent Cherenkov radiation

Optimized Design Considerations for Hybrid Undulator

Experimental Study for the Feasibility of a Crystalline Undulator

Superconducting RF Deflecting Cavity Design and Prototype for Short X-ray Pulse Generation