Abstract:Pulsed power technology has traditionally served in the field of defense technology and is generally operated in a single operation. With the increasing demand in the military and high-energy physics fields, especially in the fields of medicine [1], industry, environmental protection and electromagnetic interference, the demand for high average power is becoming more and more urgent, requiring the pulse source to be in a high repetition frequency operating state. The high-repetition-frequency high-voltage pulse source is a pulse power system that can operate at high repetition frequencies and generate high voltage pulses. Ultra-wideband electrical pulse sources with small size and all solid-state structures are easier to integrate into the system and compatible with other devices. This paper introduces the design and implementation of a high-repetition-frequency high-voltage pulse generating device. The device is mainly composed of a pulse signal source module, a power amplification module and a pulse compression module. The article describes in detail about the pulse signal generation module based on MCU (micro-controller unit) and FPGA (field programmable gatearray) with adjustable frequency adjustable pulse width at the source level, the pulse signal power amplification module based on DSRD (drift step recovery diode) [2] switch, the pulse compression module based on the principle of diode reverse recovery. The final test results show that the device can work at 1MHz repeat frequency, the output pulse peak voltage can be up to 1700V on 50 Omega load, the output pulse rising edge is less than 1 ns, and the half pulse width is up to 1.9 ns. If the pulse compression module is connected, the half pulse width can reach 1.56 ns and the compression ratio can reach 87%.

Experimental analysis of wide-spectrum oscillator with nonmatched transmission line

Design of Compact Transmission Line Transformer for High Voltage Nanosecond Pulses

A Compact High-Power Ultra-Wideband Bipolar Pulse Generator

A Compact Mesoband Microwave Radiation System.

Novel Microwave Oscillator Based On The Complementary Split-Ring Resonators

Research and Experiment of a W-Band High-Power Extended Interaction Oscillator with High Voltage

Design and Numerical Simulations of A High Power 0.15 Thz Oscillator

A Megawatt-Level Surface Wave Oscillator in Y-band with Large Oversized Structure Driven by Annular Relativistic Electron Beam

The Study Of Q-Band Sheet Beam Backward Wave Oscillator Based On A Planar U-Shaped Slot-Line Slow-Wave Structure

Experimental Study on X-band Repetitively Oversized Backward Wave Oscillator

Research on Optimized Structure of a 220-Ghz Extended Interaction Oscillator

Study on 0.34 THz Overmoded Surface Wave Oscillator

High-Voltage Nanosecond Pulse Generator Based on Two-Stage Blumlein Transmission Line

Design and Implementation of DC-to-5~MHz Wide-Bandwidth High-Power High-Fidelity Converter

Design, Implementation And Analysis Of Solid-State Megahertz Continuous High-Repetition-Frequency High-Voltage Pulse Source

Preliminary Circuit Analysis of a <inline-formula> <tex-math notation="LaTeX">$W$ </tex-math></inline-formula>-Band High-Power Extended Interaction Oscillator With Distributed Hollow Electron Beam

Mode Competition And Selection In Overmoded Surface Wave Oscillator

Experimental Study on a High-Power Subterahertz Source Generated by an Overmoded Surface Wave Oscillator with Fast Startup

Design of High-Q Millimeter-Wave Oscillator by Differential Transmission Line Loaded with Metamaterial Resonator in 65-Nm CMOS

Dual-frequency Low-Voltage Subterahertz Radial Clinotron Based on Fan-Shaped Splitter

A Portable Ultrawideband Electromagnetic Radiator with a 1.4 MW/50 Khz Solid-State Subnanosecond Pulser.