Abstract:Phase sensitive optical time domain reflectometry (Φ-OTDR) has been widely used in many applications for its distributed sensing ability on weak disturbance all along the sensing fiber. However, traditional Φ-OTDR cannot make quantitative measurement on the external disturbance due to the randomly distributed position and reflectivity of scatters within the optical fiber. Recently, some methods have been proposed to realize quantitative measurement of dynamic strain. In these literatures, the fiber with or without FBGs in practice was easily damaged and with difficulty of maintenance. PZT is employed to generate strain event in the fiber. There is a large gap compared with the real detecting environment, which will not reveal the full performance of the sensing system. In this paper, a distributed optical fiber sensing (DOFS) system for dynamic strain measurement based on artificial reflector is proposed and demonstrated experimentally. The fiber under test (FUT) is composed by four 20-meter long single mode optical fiber patch cords (OFPCs), which are cascaded with ferrule contactor/physical contact (FC/PC) connectors via fiber flanges. The fiber facet of FC/PC connector forms an artificial reflector. When the interval between the two reflectors is changed, the phase of the interference signal will also be changed. A symmetric 3×3 coupler with table-look-up scheme is introduced to discriminate the phase change through interference intensity. In our experiment, the center 10m section of the second OFPC is attached to the bottom of an aluminum alloy plate. An ordinary loudspeaker box was located on the top of the aluminum alloy plate. The dynamic strain generated by the loudspeaker box is transmitted from the aluminum alloy plate to the OFPC. Experimental results show that the proposed method has a good frequency response characteristic up to 3.2 kHz and a linear intensity response of R2=0.9986 while the optical probe pulse width and repetition rate were 100ns and 10 kHz respectively. Meanwhile, triangle and cosine amplitude-modulated (AM) dynamic strain applied on the fiber are successfully discriminated. The artificial reflectors based on FC/PCs were easily assembled and maintained, and the method of vibration transmission closely resembled the real circumstance than PZT. Therefore, these advantages will extend the potential of this Φ-OTDR technology in structure health monitoring.

Oscillator interrogated time-of-flight optical fiber interferometer for global strain measurements

Monitoring of FRP Strengthened Structures Using a Modified Time of Flight Interferometer

An Optoelectronic Oscillator‐based Strain Sensor with Extended Measurement Range

A High Performance Distributed Optical Fiber Sensor Based on Φ-OTDR for Dynamic Strain Measurement

Study of Large Strain OFDR Sensor Based on Inclined Transfer Structure

A Multiplexed Optical Fiber Sensor System For Distributed Measurement Of Structural Strains

A Distributed Optical Fiber Sensing System for Dynamic Strain Measurement Based on Artificial Reflector

Optical fiber Fabry-Perot interferometer based embeddable strain sensor with 30 nano-strain resolution

An embeddable optical strain gauge based on a buckled beam

A Fiber Strain Sensor with High Resolution and Large Measurement Scale

Distributed strain interrogation with a linearly chirped fiber Bragg grating based on an optoelectronic oscillator

Miniature Optical Fiber Strain Sensor Based on Fabry-Perot Interferometer

Large-dynamic-range fiber loop ringdown strain sensor using Frequency-shifted Interferometry

High Spatial Resolution Distributed Fiber Strain Sensor Based on Phase-Ofdr

Optical Fiber Sensor with a Lateral-Offset Structure Assisted by Virtual Vernier Effect for Stretching Strain Measurement

Advanced Fiber Optic Sensing for Cryogenic Simultaneous Temperature and Strain Measurement

Long-distance OFDR with High Spatial Resolution based on Time Division Multiplexing

Quasi-distributed frequency-modulated continuous-wave reflectometric optical fiber strain sensor

Distributed Fiber-Optic Dynamic-Strain Sensor with Sub-Meter Spatial Resolution and Single-Shot Measurement

Fiber Optic 2-D Sensor for Measuring the Strain Inside the Concrete Specimen

Extended dynamic range detection system for in-fibre Bragg grating strain sensors based on two cascaded interferometric wavelength scanners