Abstract:This paper investigates mechanisms of the surface charge dissipation of silicone rubber (SiR) after dielectric barrier discharge (DBD) plasma treatments in an open air. Electrical and physicochemical properties of the untreated and plasma treated samples were evaluated by surface and volume conductivity, surface potential decay (SPD) measurements, Fourier transform infrared (FT-IR), and water contact angle tests. Results show that the surface conductivity of the plasma treated samples evidently increases with the treatment time. The samples with a longer DBD plasma treatment time enhance the SPD rate after the positive and negative corona charging. However, an abnormal surface potential variation is observed at the beginning of the SPD after the negative corona charging. It is found that the top-bottom surface plasma treatment can further accelerate the SPD of the samples compared with the untreated and single surface plasma treated samples. The physicochemical analysis shows that the concentration of polar groups is increased after the plasma treatment, and the water contact angle is consistently declined with the increase of the plasma treatment time. The calculated trap distribution illustrates that the hole trap energy and the electron trap density of the sample are decreased after the plasma treatments. This investigation attributes the measured SPD of the untreated sample and single surface treated samples to the electrical conduction along the sample surface, but the SPD of the top-bottom surfaces plasma treated samples is enhanced by the charge neutralization and transportation through the material bulk as well as the sample top surface conduction.

Improvement of water and gas barrier properties of polycarbonate by the SiO x plasma treatment

Study on Hydrophilicity of Polymer Surfaces Improved by Plasma Treatment

Thermal Degradation Behavior and Flame Retardancy of Polycarbonate Containing Poly[(phenylsilsesquioxane)-co-(dimethylsiloxane)] and Potassium Diphenyl Sulfonate

Improve the flame retardancy and scratch resistance of polycarbonate by introducing Si/P/N contained transparent coatings

Monomers effect on the gas and humid barrier properties in PECVD deposited SiOx film on PET surface

The Power Source Effect on SiOx Coating Deposition by Plasma Enhanced Chemical Vapor Deposition

Mechanisms of Surface Charge Dissipation of Silicone Rubber Enhanced by Dielectric Barrier Discharge Plasma Treatments

The stability of radio-frequency plasma-treated polydimethylsiloxane surfaces

Plasma Treatment of Polymethyl Methacrylate to Improve Surface Hydrophilicity and Antifouling Performance

Deposition of Silicon Oxide Coatings by Atmospheric Pressure Plasma Jet for Oxygen Diffusion Barrier Applications

Effect of Nanoparticles Plasma Treatment on Corona Resistance of Polyimide Composite Films

Treatment of Polymeric Films Used for Printed Electronic Circuits Using Ambient Air DBD Non-Thermal Plasma

A Study of the Influence of Process Parameters of AP PECVD on the Mechanical Properties of Silica-like Films Deposited on Polycarbonate

Modifying wetting properties of PI Film: The impact of surface texturing and CF 4 and O 2 plasma treatment

Surface Hydrophilicity Improvement of Rgp Contact Lens Material by Oxygen Plasma Treatment

Robust hydrophobic coating on glass surface by an atmospheric-pressure plasma jet for plasma-polymerisation of hexamethyldisiloxane conjugated with (3-aminopropyl) triethoxysilane

Corona Resistance Improvement of Polyimide Films by Non-Thermal Plasma Modification

Effect of air plasma treatment on the mechanical properties of polyphenylene sulfide/glass fiber cloth composites

Flame retarding mechanism of polycarbonate containing methylphenyl-silicone

Polypropylene Surface Plasma Modification Using Middle Frequency Power Supply

A P/Si-containing Flame Retardant Towards Simultaneous Improvement of the Toughness, Transparency and Fire Safety of Polycarbonate