Abstract:In the traditional calculation model of mesh stiffness, the tooth root crack is commonly assumed to be in a closed state. However, the gear tooth crack will open under the action of mesh force in the meshing process, the mesh stiffness of the cracked tooth and the dynamic response of gear system is thus different from the closed crack case. There almost no studies have been done to investigate the influence of tooth crack open state on mesh stiffness and dynamic response. Thus, this paper presents an improved mesh stiffness calculation model of the cracked gear, in which the effective compression section and the neutral layer of the cracked tooth are re-evaluated considering the crack opening state. Then, the accuracy of the proposed model is verified by the finite element method (FEM), and the differences of mesh stiffness and statistical indicators of the dynamic response between the proposed and traditional models are further studied. The mesh stiffness calculation results show that the proposed model achieves a higher accuracy than the traditional model. And its precision gradually increases as the crack grows, which can be improved by 2.35% in the case of large crack (48.38% crack) when compared to the traditional model. The fault response signal obtained from the traditional model yields a larger amplitude than the actual situation, which will lead to errors of the statistical indicators used for fault diagnosis, in particular, the RMS value can be up to an average percentage difference of 11.98% under the large crack (48.38% crack). It is concluded that the proposed model has a higher accuracy for calculating the mesh stiffness of the cracked gear and can be further used to serve the fault diagnosis and detection of the gear system.

Effect of spur gear crack on rotor dynamic response

Influence of tooth crack parameters on bearing vibration signal of a geared rotor

Study on Fatigue Degradation Behavior of a Cracked Rotor Subjected to Lateral Vibration

Dynamic Analysis of A Geared Rotor System Considering A Slant Crack on the Shaft

Gear Crack Assessment Based on Cyclic Correlation Analysis

Vibration characteristic analysis of spur gear systems under tooth crack or fracture

Vibrations Of Cracked Gear-Rotor System: Tooth Root Crack Versus Shaft Transverse Crack

Vibration Feature Evaluation of the Motor-Gear System with Gear Tooth Crack and Rotor Bar Error

An improved time-varying mesh stiffness algorithm and dynamic modeling of gear-rotor system with tooth root crack

Vibration Analysis of Rotor with Transverse Surface Cracks

Contribution of friction-induced vibration to the realistic failure analysis of spur gear cracked teeth

Dynamic Modelling of Gear System with Gyroscopic Effect and Crack Detection Analysis

Research on the time-varying mesh stiffness method and dynamic analysis of cracked spur gear system considering the crack position

Mesh Stiffness Modeling and Dynamic Simulation of Spur Gears with Body Crack under Speed Fluctuation Condition

Investigation of tooth crack opening state on time varying meshing stiffness and dynamic response of spur gear pair

Vibration analysis for tooth crack detection in a spur gear system with clearance nonlinearity

The Effects of Crack on the Transmission Matrix of Rotor Systems

Nonlinear dynamics of a spur gear pair with tooth root crack based on an amplitude modulation function

The influence of cracks in rotating shafts

THE DYNAMIC MODELLING OF A SPUR GEAR IN MESH INCLUDING FRICTION AND A CRACK

Detecting the 3D Spatial Varying Crack Evolution-Induced Vibration of Gearbox Through a System Level Rigid-Flexible Coupling Model