Abstract:In the traditional calculation model of mesh stiffness, the tooth root crack is commonly assumed to be in a closed state. However, the gear tooth crack will open under the action of mesh force in the meshing process, the mesh stiffness of the cracked tooth and the dynamic response of gear system is thus different from the closed crack case. There almost no studies have been done to investigate the influence of tooth crack open state on mesh stiffness and dynamic response. Thus, this paper presents an improved mesh stiffness calculation model of the cracked gear, in which the effective compression section and the neutral layer of the cracked tooth are re-evaluated considering the crack opening state. Then, the accuracy of the proposed model is verified by the finite element method (FEM), and the differences of mesh stiffness and statistical indicators of the dynamic response between the proposed and traditional models are further studied. The mesh stiffness calculation results show that the proposed model achieves a higher accuracy than the traditional model. And its precision gradually increases as the crack grows, which can be improved by 2.35% in the case of large crack (48.38% crack) when compared to the traditional model. The fault response signal obtained from the traditional model yields a larger amplitude than the actual situation, which will lead to errors of the statistical indicators used for fault diagnosis, in particular, the RMS value can be up to an average percentage difference of 11.98% under the large crack (48.38% crack). It is concluded that the proposed model has a higher accuracy for calculating the mesh stiffness of the cracked gear and can be further used to serve the fault diagnosis and detection of the gear system.

THE DYNAMIC MODELLING OF A SPUR GEAR IN MESH INCLUDING FRICTION AND A CRACK

Investigation of tooth crack opening state on time varying meshing stiffness and dynamic response of spur gear pair

Mesh Stiffness Modeling and Dynamic Simulation of Spur Gears with Body Crack under Speed Fluctuation Condition

Dynamic Modeling and Analysis of Spur Gears Considering Friction–vibration Interactions

An improved dynamic model of spur gears considering delayed meshing out of the contact point due to root crack

Analytical models of mesh stiffness for cracked spur gears considering gear body deflection and dynamic simulation

Dynamic Characteristics of Spur Gear System with Tooth Root Crack Considering Gearbox Flexibility

Dynamic modelling of flexibly supported gears using iterative convergence of tooth mesh stiffness

Dynamic modeling of spur gear transmission system with evolutive coupling fault of fatigue crack and wear

Dynamic Modeling of Gear System Based on 3D Finite Element Model and Its Application in Spalling Fault Analysis

Dynamic model of a helical gear pair considering tooth surface friction

Mathematical Modeling and Dynamic Analysis of Planetary Gears System with Time-Varying Parameters

Analysis of spur gearbox dynamics considering tooth lubrication and tooth crack severity progression

Dynamic Behavior Analysis of Spur Gears with Constant & Variable Excitations Considering Sliding Friction Influence

Dynanic Simulation of Helical Gears with Crack Propagating in to Gear Body

Mesh stiffness modelling and dynamic simulation of helical gears with tooth crack propagation

An improved dynamic model of spur gear transmission considering coupling effect between gear neighboring teeth

Contribution of friction-induced vibration to the realistic failure analysis of spur gear cracked teeth

Improved Mesh Stiffness Method and Vibration Analysis of a Planetary Gear System with a Spatial Tooth Crack

Research on the time-varying mesh stiffness method and dynamic analysis of cracked spur gear system considering the crack position

Dynamic modelling of the gear system under non-stationary conditions using the iterative convergence of the tooth mesh stiffness