Abstract:<p>The increasing demand of ultra-high purity aluminum for technological applications has triggered the improvement of purification methods during the recent decades. Some of the most relevant applications for ultra-high purity aluminum include electrolytic condensers, transistors, integrated circuit conductors, magnetic disks substrates and low-temperature superconducting magnets. The most commonly used industrial technique for refining high purity aluminum is the three-layer electrolytic process, reaching purification levels of up to 4N8 (99,998 wt.%). An alternative and less capital intensive method to achieve such purification level is fractional crystallization. While the three-layer electrolytic process remains almost unchanged among its proprietaries, the fractional solidification processes vary considerably on their techniques and setups used to achieve an efficient segregation of impurities from the base metal. The purpose of this article is to compare the cooled finger and zone melting, two existing fractional crystallization methods, available at the Institut für Metallurgische Prozesstechnik und Metallrecycling (IME) of the RWTH Aachen University. The purification effect caused by different types of convection from these two fractional crystallization techniques was experimentally shown and the common characteristics among fractional crystallization equipment; i.e. growth rate, thermal gradient and purification rate, were investigated. The competitive advantage of the cooled finger over zone melting was demonstrated. Although both techniques are capable of refining aluminum, the design of the cooled finger favors a better impurity segregation.</p>

Ultra-high vacuum compatible induction-heated rod casting furnace

Ultra-high vacuum compatible induction-heated rod casting furnace

Ultra-high vacuum compatible preparation chain for intermetallic compounds

A Nearly Zero Temperature Gradient Furnace System for High Pressure Multi-Anvil Experiments

Preparation of Highly Perfect Aluminum Crystal by Cold-Crucible Induction Melting in Ultra-high Vacuum

Preparation of a (Ca,Sr,Ba)ZrO3 Crucible by Slip Casting for the Vacuum Induction Melting of NiTi Alloy

Temperature field calculation on cold crucible continuous melting and directional solidifying Ti5OAl alloys

Multiphysics modeling and experimental validation of heat and mass transfer for the vacuum induction melting process

Feasibility of Directional Solidification of Silicon Ingot by Electromagnetic Casting

Sintered crucible coating for highly under-cooled Cu-Ni-Fe alloys

Temperature Field Calculation on Cold Crucible Continuous Melting and Directional Solidifying Ti50Al Alloys

High-Temperature (940 °C) Furnace in 18/20 T Cold Bore Magnet

Isothermal furnace for long-term in situ and real-time X-radiography solidification experiments

An experimental instrument for solidification and in situ characterization of the nucleation behavior of high-melting metal under a high magnetic field

Alternative fractional crystallization-based methods to produce high-purity aluminum

Obtaining high-purity fused refractory oxides

A method of further purification of zone-refined aluminum by cold-crucible levitation melting in ultra-high vacuum

Preparation of Zr-Base Bulk Amorphous Alloy by Tilt Casting Method Using Ladle Hearth Type Arc Furnace

MHD-processes and equipment for continuous casting of aluminum alloy ingots

Research and Development of Cold Crucible Melting and Casting Technology