Abstract:The constraints of traditional manufacturing techniques have led to the generation of a considerable amount of waste superalloy, causing substantial resource wastage. The primary concern with waste superalloys lies in the excessive presence of inclusions and impurity elements, rendering them unsuitable for further utilization. This study proposes the use of directional solidification combined with electron beam melting and refining (EBMR) to prepare FGH4096 superalloy ingots (Φ120 mm), which offers a promising approach to produce large-sized powder superalloy master alloy ingots with high-purity and high homogeneity. It is found that the secondary dendrite arm spacing and the size of the γ' phase in the alloy are significantly reduced after EBMR treatment. The concentration of O and N can be decreased to 5.7 and 0.6 ppmw, respectively. The size of inclusion can be reduced below 8.69 μm and the inclusion numbers reduce by over 50 % compared with both conventional ingots. A droplet transfer mode and melt convection mode mechanism have been proposed, which accurately predicts the melting temperature and melt flow. A quantitative study is conducted on the influence of inclusion density, the contact angle between inclusions and melt, and the surface tension of the melt on capillary forces. The results indicate that the capillary forces between inclusions in the melt range from 1.8 × 10 −19 N and 1.9 × 10 −17 N. Furthermore, the collision-aggregation behavior of inclusions in the melt is discussed, and an estimate of the tendency of inclusion collision-aggregation is provided. The enrichment of inclusions in the EBMR ingot is primarily the result of turbulent collision. The Marangoni effect and the extremely high surface temperature of the melt promote the collision and agglomeration of inclusions, causing them to accumulate rapidly at the melt surface. Moreover, the thorough removal of inclusions through the decomposition and dissolution process of the electron beam offers theoretical backing for the preparation of superalloys through electron beam melting and high-purity refining.

AN INTRODUCTORY DISCUSSION ABOUT 1200 Kw EB FURNACE MELTING PROCESS

Calculation of Flow, Heat Transfer and Evaporation During the Electron Beam Cold Hearth Melting of Ti-6Al-4V Alloy

Research on directional solidification combined with electron beam melting and refining for recycling of FGH4096 alloy scraps

Feasibility of Melting NbC Using Electron Beam Powder Bed Fusion

Numerical Modeling of Electron Beam Cold Hearth Melting for the Cold Hearth

Electron Beam Cold Hearth Melting of TC4

Numerical Study of Temperature Field and Melt Pool Properties during Electron Beam Selective Melting Process with Single Line and Multiple Line Scanning

Molten pool flow behavior and influencing factors in electron beam selective melting of IN738 superalloy

Electron Beam Selective Melting of 316L Stainless Steel Powder

Analysis of the melting process of carbon-bearing pellets in iron bath, slag bath and graphite crucible

Electron Beam Melting of Niobium Alloys from Blended Powders

Numerical analysis and process optimization of electron beam melting for superalloys

Purification of Niobium by Electron Beam Melting

Modeling and Experimental Validation of the Electron Beam Selective Melting Process

Grain refinement, hardening and metastable phase formation by high current pulsed electron beam (HCPEB) treatment under heating and melting modes

Design and Construction of a Laboratory-Scale Direct-Current Electric Arc Furnace for Metallurgical and High-Titanium Slag Smelting Studies

Research on energy utilization of electron beam melting for silicon purification

Fluid Flow and Heat Transfer During the Electron Beam Cold Hearth Remelting Process

Control of the floating zone stability during electron beam melting process of Ni-25%Si alloy

Mechanisms for removing impurities in a single crystal superalloy by electron beam drip melting

Design of Metal Poeder Preheating System in Electron Beam Selective Melting