Copper and Zirconium Codoped O3-Type Sodium Iron and Manganese Oxide as the Cobalt/Nickel-Free High-Capacity and Air-Stable Cathode for Sodium-Ion Batteries

Ya-Min Zheng,Xiao-Bao Huang,Xiao-Meng Meng,Shou-Dong Xu,Liang Chen,Shi-Bin Liu,Ding Zhang

DOI: https://doi.org/10.1021/acsami.1c12684

2021-09-14

Abstract:Considering the abundance of iron and manganese within the Earth's crust, the cathode O3-NaFe0.5Mn0.5O2 has shown great potential for large-scale energy storage. Following the strategy of introducing specific heteroelements to optimize the structural stability for energy storage, the work has obtained an O3-type NaFe0.4Mn0.49Cu0.1Zr0.01O2 that exhibits enhanced electrochemical performance and air stability. It displays an initial reversible capacity of 147.5 mAh g–1 at 0.1C between 2 and 4.1 V, a capacity retention ratio exceeding 69.6% after 100 cycles at 0.2C, and a discharge capacity of 70.8 mAh g–1 at a high rate of 5C, which is superior to that of O3-NaFe0.5Mn0.5O2. The codoping of Cu/Zr reserves the layered O3 structure and enlarges the interlayer spacing, promoting the diffusion of Na+. In addition, the structural stability and air stability observed by Cu-doping is well maintained via the incorporation of extra Zr favoring a highly reversible phase conversion process. Thus, this work has demonstrated an efficient strategy for developing cobalt/nickel-free high-capacity and air-stable cathodes for sodium-ion batteries.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsami.1c12684.Rietveld refinement for the XRD pattern of NFMC-0.1 cathode sample; SEM imaging for all the codoped cathode samples, SEM imaging for three cathode samples treated by water immersion; the cyclic curves and the charge–discharge profiles for the codoped cathode samples; the initial charge–discharge curves of NFMCZ-0.01 in different voltage ranges; in situ XRD patterns of NFMCZ-0.01; charge–discharge curves for the three cathode samples after water immersion treatment; the survey spectrum for the codoped cathode sample NFMCZ-0.01 (Figures S1–S8); refined crystal parameters for NFM, NFMC-0.1, and NFMCZ-0.01 by single-phase simulation; comparison of cyclic stability between the previous relevant literature and this work (Tables S1–S4); and detailed procedure to make GITT analysis (PDF)This article has not yet been cited by other publications.

materials science, multidisciplinary,nanoscience & nanotechnology

What problem does this paper attempt to address?

The paper aims to address the issues of cathode materials for sodium-ion batteries, specifically by developing a high-capacity and air-stable cathode material that is free of cobalt and nickel. The research team prepared a novel cathode material, O3-NaFe0.4Mn0.49Cu0.1Zr0.01O2, by introducing a co-doping strategy with copper (Cu) and zirconium (Zr) into O3-type sodium iron manganese oxide. This material exhibits excellent electrochemical performance and air stability, with a high initial reversible capacity of 147.5 mAh g^-1. After 100 cycles, the capacity retention rate exceeds 69.6%, and it maintains a discharge capacity of 70.8 mAh g^-1 even at a high rate (5C).

The main objectives of the paper are:
1. **Improve Electrochemical Performance**: Optimize structural stability through Cu/Zr co-doping to enhance the electrochemical performance of sodium-ion batteries.
2. **Enhance Air Stability**: Ensure the material has good stability in air, reducing the likelihood of reactions with moisture in the air.
3. **Develop Low-Cost Materials**: Utilize the abundant elements iron and manganese on Earth to replace expensive cobalt and nickel, thereby reducing costs.

These improvements provide important guidance for the development of cathode materials for future sodium-ion batteries.