Abstract:A new dual-imaging-unit atomic force microscope (DIU-AFM) was developed for wide-range length metrology. In the DIU-AFM, two AFM units were combined, one as a reference unit, and the other a test one. Their probes with Z piezo elements and tips were horizontally set in parallel at the same height to reduce errors due to geometric asymmetry. An XY scanner was attached to an XY block that was able to move in the X direction with a step of about 500 nm. A standard porous alumina film was employed as the reference sample. Both reference sample and test sample were installed at the center of the AT scanner on the same surface and were simultaneously imaged. The two images had the same lateral size, and thus the length of the test sample image could be accurately measured by counting the number of periodic features of the reference one. The XY block together with the XY scanner were next moved in the X direction for about 1.5 mum and a second pair of reference and test images were obtained by activating the scanner. In this way, a series of pairs of images were acquired and could be spliced into two wide-range reference and test images, respectively. Again, the two spliced images were of the same size and the length of test image was measured based on the reference one. This article presents a discussion about the structure and control of the DIU-AFM system. Some experiments were carried out on the system to demonstrate the method of length calculation and measurement. Experiments show a satisfactory result of wide-range length metrology based on the hexagonal features of the porous alumina with a periodic length of several tens of nanometers. Using this method the DIU-AFM is capable of realizing nanometer-order accuracy length metrology when covering a wide range from micron to several hundreds of microns, or even up to millimeter order. (C) 2004 Wiley-Liss, Inc.

AFM probe with the U-shaped cross-sectional cantilever for measuring the ultra-low coefficient of friction of 10−6

High Quality-Factor Quartz Tuning Fork Glass Probe Used In Tapping Mode Atomic Force Microscopy For Surface Profile Measurement

Surface Profile Measurement of Micro-Optics by Using a Long Stroke Atomic Force Microscope

Towards High Accuracy Surface Profile Characterization in Atomic Force Microscopy

Research of the Atomic Force Microscopy Profilometer System

Calibration of the Effective Spring Constant of Ultra-Short Cantilevers for A High-Speed Atomic Force Microscope

Direct Measurement of Plowing Friction and Wear of a Polymer Thin Film Using the Atomic Force Microscope

Measurement of Sub-Surface Microstructures Based on a Developed Ultrasonic Atomic Force Microscopy

Methodology for Measurement of Submicron Metallic Wire's Local Electrical Conductivity by Applying Four-points AFM Probe Technique

T0301-2-5 Modifying the Structure of Microwave AFM Probe for Improving the Sensitivity in the Measurement of Electrical Properties

A compact CCD-monitored atomic force microscope with optical vision and improved performances.

Atomic Force Microscope in Liquid with A Specially Designed Probe for Practical Application

Optimization Of The Tip Of Microwave Afm Probe

NOVEL AFM PROBE FOR LOCAL CONDUCTIVITY MEASUREMENT

A Horizontal Atomic Force Microscope and Its Applications

Quantitative Measurement of Submicrometre Electrical Conductivity

Wide-range length metrology by dual-imaging-unit atomic force microscope based on porous alumina.

A Novel Atomic Force Microscope with High Stability and Scan Speed

Improved Wedge Method of the AFM Friction Force Calibration

Several Fundamental Problems in Hydrophobic Force Measurements by Using AFM

Micro Contact and Stick-Slip Number Between Afm Probe Tip and Sample Surface