Abstract:JAERI has been proposing a high-intensity proton accelerator with energy of 1.5GeV and a beam power of 8 MW for the Neutron Science Project (NSP)[1]. This paper describes a conceptual design study for the RF system; a candidate of amplifier for the low energy accelerating part, an RF system efficiency and required AC power are estimated for the high energy a ccelerating part. 1 RF SYSTEM OF NSP ACCELERATOR The NSP is aiming at exploring nuclear technologies for nuclear waste transmutation and various basic research fields such as condensed matter physics based on a proton induced spallation neutron. The accelerator will consist of RFQ, DTL for the low energy part and superconducting (SC) linac for the high energy part. It should be operated both in pulse and CW. The RF system is most costly part for a high power RF accelerator and one of the major components to determine the reliability. The accelerator is required with CW operation for application of the nuclear waste transmutation, and is required with high current pulse operation for the basic research field. This requirement is the essential feature of the NSP accelerator. A preliminary specific at on for the accelerator is given in Table 1. The final value of energy/current and pulse time structure will be determined from further discussion on the user requirement and the cost estimation. Figure 1 shows a block diagram of an RF system for the NSP accelerator. As a main option, we chose a frequency combination of 200 600 MHz for the accelerator. There is three times frequency jump between low and high energy part. In the first consideration, we chose a klystron system in the 600 MHz part. Klystrons are widely used as high power RF source and are regarded as a reliable device. Grid tubes such as a tetrode and a Diacrode will be applied in 200 MHz part. In the conceptual design, the accelerator requires the total peak RF power of about 300 kW for RFQ, 9MW for DTL and 29 MW for SC linac for the pulse operation.

Development of RF system for RAON superconducting linear accelerator

Development of cryogenic systems for the RAON accelerator

Beam instrumentation system development and commissioning in ssrf

Vacuum system of the RAON

Superconducting magnets for the RAON electron cyclotron resonance ion source

Scl3 cryomodules for RAON

Beam diagnostic system for the SCL3 of the RAON

Conventional magnet system in the RAON linac and KoBRA beamline

Review of the 70-MeV cyclotron as the ISOL beam driver at RAON

Beam dynamics for RAON linac and beam lines

Fabrication and RF test of the 500 MHz-RFQ linear accelerator for a transportable neutron source RANS-III

Status of survey network and alignment

An RF power system for NSP high intensity proton accelerator at JAERI

Design, Fabrication, and Beam Commissioning of A Continuous-Wave Four-Rod Rf Quadrupole

Development of Beam Irradiation System for Life Science Research at RAON

Design and Realization of a Single Klystron-Based Radio Frequency System for a Radio Frequency Quadrupole and a Drift Tube Linac

The low level RT control system of PLS-II storage ring at 400 mA 3.0 GeV

R&D Status Of Sfrfq Accelerating System

Commissioning of RF system of the 200 MeV proton cyclotron

Development of a prototype superconducting radio-frequency cavity for conduction-cooled accelerators

Design and performance of the digital LLRF control system for isotope production cyclotron