Abstract:The KSTAR device is a tokamak with a fully superconducting (SC) magnet system, which enables an advanced quasi-steady-state operation. Initial operation of the KSTAR SC magnet system has been accomplished for the first plasma discharge operation. The SC magnet system consists of 16 toroidal field (TF) coils and 14 PF coils, magnetic structures, SC buslines, current leads, and monitoring and protection system. One of the uniqueness of the KSTAR device is using the Nb3Sn superconductor both in 16 TF coils and in 10 PF coils except 4 PF coils made of NbTi. The objectives of the commissioning of the superconducting magnet are to verify the engineering reliability of all the superconducting magnets at the operating conditions and to develop the operational controllability for the successful plasma startup. The target parameters of the initial operation are TF coil current of 15 kA, PF coil current up to 4 kA and PF blip and feedback control using plasma control system (PCS). All the superconducting magnets were operated reliable without any severe failure to preventing the first plasma operational target. The TF magnet was operated reliably up to 15 kA for 8 hours and the temperature rising of TF magnet is less than 0.1 K. There was no quench during operation including slow and fast discharges. As the PF commissioning, the controllability of each power supply has been tested by using dummy copper load and each SC PF coil. After the individual test of the PF coil and power supply, integrated control was accomplished for the field null formation and for loop voltage generation to meet the first plasma discharge. The ac losses of the several PF coils have been measured by applying the single trapezoidal current and dc biased sinusoidal current with various ramp rate. The hysteresis loss of PF1 coil was less than 180 mJ/cc and the time constant of the coupling loss was less than 50 ms after 500 pulse operations. The field distortion by the Incoloy908 material in the superconductor was measured and modification in the PF coil current scenario has been adopted also. By the feedback control of the plasma current and position, the plasma current could be sustained up to 860 ms under the limited volt second of 1.1 Wb. FIG. 1. Configuration of the KSTAR superconducting magnet system FIG. 2. Bird eye view of the KSTAR superconducting magnet system

Conventional magnet system in the RAON linac and KoBRA beamline

Superconducting magnets for the RAON electron cyclotron resonance ion source

Development of RF system for RAON superconducting linear accelerator

Beam test results of the orbit correction at the low-energy superconducting accelerator section in the RAON accelerator

Beam instrumentation system development and commissioning in ssrf

Beam dynamics for RAON linac and beam lines

Development of cryogenic systems for the RAON accelerator

Beam diagnostic system for the SCL3 of the RAON

Vacuum system of the RAON

Scl3 cryomodules for RAON

Commissioning Status of the Linac for the Facility for Rare Isotope Beams

Development of the collinear laser spectroscopy (CLaSsy) at RAON

Status of survey network and alignment

Review of the 70-MeV cyclotron as the ISOL beam driver at RAON

Development of Beam Irradiation System for Life Science Research at RAON

Design Updates and Analysis of the Korean Fusion Demonstration Reactor Superconducting Toroidal Field Magnet System

Ssrf beam diagnostics system commissioning

Commissioning Results of the KSTAR Superconducting Magnet System for the First Plasma Operation

Development and Status of the FRIB 28 GHz SC ECRIS

Re-assembly and test of a COMB dipole magnet with STAR wires

High Temperature Superconducting Magnets for Efficient Low Energy Beam Transport Systems