Abstract:An interdigital H-mode drift tube linac (IH-DTL), which is aimed at proton medical facilities, has been proposed and developing at Tsinghua University. Considering following 3 MeV RFQ in the platform of CPHS (Compact Pulse Hadron Source at Tsinghua University) and XiPAF (Xi`an Proton Application Facility) project, the input energy of IH-DTL is 3 MeV and the RF frequency is 325 MHz. The proton beam can be accelerated from 3 MeV to 7 MeV and the peak current of the beam at the exit of the cavity is about 15 mA. In order to simplify the fabrication, A KONUS structure without focusing element in the cavity is chosen. The RF design of single CELL and the primary dynamics design is done. The co-iteration of dynamics simulation and RF calculation of whole cavity is undergoing. INTRODUCTION Facilities used for proton and carbon therapy become more and more popular. IH DTL has been used widely in the injector of clinical synchrotrons because of its high RF power efficiency at low beam velocity (beta<0.1) [1]. A 216 MHz IH-DTL has been developed for HICAT (Heidelberg Heavy Ion CAncer Therapy) project [2]. There are 4 KONUS (Kombinierte Null Grad Struktur) sections and three triplets in the tank. The proton beam can be accelerated from 0.4 MeV to 7 MeV in 3.76 m. The high effective gradient is 5.5 MV/m [3]. Another kind of proton IH DTL is developed via APF (Alternating Phase Focusing) beam dynamics. The length of this cavity is ~1.7 m. It can accelerate 10mA proton beam to 7.4 MeV at 200 MHz [4]. Those two kind of beam dynamics are both applied in IH cavity widely. Considering the platform of CPHS (Compact Pulse Hadron Source at Tsinghua University) and XiPAF (Xi`an Proton Application Facility) project, a 325 MHz IH-DTL is proposed and developing. The main parameters of this linac is shown in Table1. In order to simplify the fabrication, there is no focusing elements in the cavity. That makes the need of short length and high effective gradient. The total length of this IH-DTL is less than 1.2 m. That motivates the optimization of single cell geometry to get high acceleration gradient and high shunt impedance. The design and optimization process of single cell is described in the 2 section. Almost all the KONUS dynamics design is done by LORASR code (LOngitudinale und RAdiale Strahldynamikrechnungen mit Raumladung). A new and simple Matlab code has been developed to produce the primary structure of an IH-DTL with KONUS lattice. The process of code development and primary design results are described in the 3 section. Table 1: Parameters of 325 MHz IH-DTL

Design and Realization of a Single Klystron-Based Radio Frequency System for a Radio Frequency Quadrupole and a Drift Tube Linac

Radio frequency measurement and tuning of a 13 MeV Alvarez-type drift tube linac for a compact pulsed hadron source

Design of RF Power System for CPHS

RF power system for compact pulsed hadron source

Physical Design and Multi-Physics Analysis of a 200 MHz Continuous Wave Radio Frequency Quadrupole Accelerator for a Proton Accelerator Facility

Design of the CPHS RFQ Linac at Tsinghua University

RF AND PRIMARY BEAM DYNAMICS DESIGN OF A 325 MHz IH-DTL

Design of a 162.5 MHz Superconducting Radio-Frequency Quadrupole for High-Intensity Proton Acceleration

Tuning and Cold Test of A Four-Vane Rfq with Ramped Inter-Vane Voltage for the Compact Pulsed Hadron Source

Design of a compact RFQ linac for the transportable neutron source

Fabrication and cold test of prototype of spatially periodic radio frequency quadrupole focusing linac

Beam dynamics design and irradiation experiment of beam loss for a CW 100-mA proton RFQ

Development of a Radio-Frequency Quadrupole Accelerator for the HL-2A/2M Tokamak Diagnostic System

Research on drift tube linac model cavity for CPHS

IH-DTL Design with Modified KONUS Beam Dynamics for a Synchrotron-Based Proton Therapy System

Beam dynamics design and error study of the coupled structure with ladder RFQ and IH-DTL

Physical design of a single-amplifier-driven proton linac injector for a synchrotron-based proton-therapy system in China

Proposal and design of 81.25 MHz heavy ion drift tube linacs for BISOL

Design of the Input Power Coupler for Boron Neutron Capture Therapy Drift Tube Linac

Design, Fabrication, and Beam Commissioning of A Continuous-Wave Four-Rod Rf Quadrupole