Abstract:We demonstrate 40 Gb/s all-optical clock recovery by using a monolithic integrated amplified-feedback laser (AFL) with coherent injection-locked method. The AFL consists of a gain-coupled DFB laser and an optical amplified feedback external cavity. With proper design and operation of AFL, the device can work at self-pulsation state that resulted from the beating between two lasing modes. The self-pulsation can be injection-locked to the optical clock embedded in input data streams. Due to different work mechanisms, there are two all-optical clock recovery operation modes: incoherent injection-locked and coherent injection-locked. It's predicted that the coherent injection method has various advantages: 1) requiring low injection power recovery, 2) independent of the bit rate and 3) introducing little timing jitter to the recovered clock. The robustness of coherent clock recovery is confirmed by our experimental results. We set up a return-to-zero (RZ) pseudorandom binary sequence (PRBS) data streams all-optical clock recovery system. This coherent injection-locked based clock recovery method is optical signal noise ratio (OSNR) and chromatic dispersion (CD) degeneration tolerant, and has low timing jitter and high sensitivity.

Low-timing-jitter all-optical clock recovery for 40 Gbits/s RZ-DPSK and NRZ-DPSK signals using a passively mode-locked quantum-dot Fabry-Perot semiconductor laser

All-Optical, Bit-Rate Tunable Clock Recovery For Nrz-Ask Signals

Low timing jitter 40 Gb/s all-optical clock recovery based on an amplified feedback laser diode

40Gbits/s All-Optical Clock Recovery for Degraded Signals Using an Amplified Feedback Laser

Investigation on All-Optical Clock Recovery from RZ-Format Data at 64Gbit/s by Using a Two-Section Index-Coupled DFB Laser

100 Gb/s All-Optical Clock Recovery Based on a Monolithic Dual-Mode DBR Laser

Low-Phase-Noise Clock Recovery from NRZ Signal and Simultaneous NRZ-to-RZ Format Conversion

Optical clock recovery with dual-wavelength output from degraded RZ and NRZ signals

Experimental Demonstration Of An All-Optical Clock And Data Recovery Technology For 10 Gb/S Nrz-Dpsk Signals

All-Optical Clock Recovery From 40 Gbit/S Rz Signal Based On Microring Resonators

Influence Factors of an All-Optical Recovered Clock from Two-Section Dfb Lasers

All-Optical Clock Recovery for 20 Gb/s Using an Amplified Feedback DFB Laser

All-optical clock recovery using a ridge width varied two-section partly gain-coupled DFB self-pulsation laser

100-GHz wavelength-tunable all-optical clock recovery with Fabry-Perot filter and semiconductor optical amplifier

40 GHz All-Optical Clock Recovery Using Cross-Absorption in an Electro-Absorption Modulator Inside a Fiber Ring Laser

Multiwavelength All-Optical Clock Recovery of Non-Return-To-Zero Data

Using Signal Pre-Distortion to Enhance the Performance of All-Optical Clock Recovery

100-Ghz All-Optical Clock Recovery with Fabry-Perot Cavity and Semiconductor Optical Amplifier

All-optical Subharmonic Clock Recovery Using an Injected Mode-locked Fiber Ring Laser

A novel approach for clock recovery without pattern effect from degraded signal

40 Gb/s All-Optical Packet Clock Recovery with Ultrafast Lock-in Time and Low Inter-Packet Guardbands.