Abstract:Fully developed turbulent pipe flow at Re=11300 as well as Re=5300 is measured by PIV using water as working fluid. Excellent agreement with DNS (Direct Numerical Simulation) by Satake (2000) is achieved by choosing optimum measurement parameters such as spatial resolution, time separation of two images, and number of samples. The test section is 6.7m long stainless steel pipe with transparent PIV measurement section attached seamlessly at the end. The measurement section consists of transparent acrylic circular pipe of 1mm thick and water jacket with square cross section. The water jacket reduces the image distortion due to the pipe curvature in almost entire area of the pipe cross section to negligible level except for the region very close to the pipe wall. For turbulent flow measurement using PIV, the requirement for spatial resolution is very severe in order to resolve the fluctuating velocity field especially at high Reynolds number. Therefore, higher magnification is chosen at the cost of the size of measurement area to assure enough spatial resolution. Consequently, the size of the measurement area is half of the pipe radius and measurement is performed at two regions which are called near-wall region and pipe center. For image analysis, the iterative multi-step cross-correlation algorithm with spatio-temporal gradient method for subpixel refinement is used. Detail of the algorithm can be found in Scarano (1999) and Sugii (2000). The smallest interrogation window is 8x16 pixels which corresponds to 249 x 585μm. The near-wall structure is observed from vector map of fluctuating in-plane velocity components and out-of-plane component of vorticity fluctuation. The shear layer structure is clearly shown by vorticity fluctuation and ejection and sweep motion is also observed. The mean velocity profile and statistics are calculated from 4000 samples of vector map by first taking temporal statistics and then spatial average along streamwise direction and compared with DNS in non-dimensional form using friction velocity. Since accurate measurement of friction velocity is essential for the comparison with DNS, using pressure gradient is not appropriate due to the relatively small pressure drop along the pipe. Therefore, curve-fitting method using near-wall turbulent model developed by McEligot (1984) is applied to calculate friction velocity from the velocity profile in buffer region.

Pipe Roughness Identification of Water Distribution Networks: The Full Turbulent Case

Research on Friction Factors Calibration of Water Distribution System

Two-dimensional Pipe Leakage Through a Line Crack in Water Distribution Systems

Pipe burst hydraulic model of water distribution system and pipe burst location

Efficient Numerical Approach for Simultaneous Calibration of Pipe Roughness Coefficients and Nodal Demands for Water Distribution Systems

Pressure-balanced Saint–Venant Equations for Improved Asymptotic Modelling of Pipe Flow

Better Water Demand and Pipe Description Improve the Distribution Network Modeling Results

Skeletonizing Pipes in Series Within Urban Water Distribution Systems Using a Transient-Based Method

Pipe Friction Parameters Identification Method Based on Moore-Penrose Pseudo-Inverse Solution

Measurements of turbulence statistics and near-wall structure of fully developed pipe flow at high Reynolds number

Simultaneous Optimal Estimation of Roughness and Minor Loss Coefficients in a Pipeline

APPLICATION OF DIFFERENT TURBULENT MODELS IN CALCULATION OF FLOW RESISTANCE IN PIPELINES AND COMPARISON THEREOF

Pipe Resistance Coefficients Identification of Water Networks Considering Solvable Conditions

A multi-state description of roughness effects in turbulent pipe flow

Optimizing Intermittent Water Supply in Urban Pipe Distribution Networks

Bayesian Approach for Joint Estimation of Demand and Roughness in Water Distribution Systems

Prediction of Mean Turbulent Flow Velocity in a Permeable-Walled Pipe

Leakage Localization in Water Distribution Networks: A Model-Based Approach

Reconstructing transient pressures in pipe networks from local observations by using physics-informed neural networks

Dynamical stability of water distribution networks

Short Overview of Early Developments of the Hardy Cross Type Methods for Computation of Flow Distribution in Pipe Networks