Abstract:Hydraulic models have been widely used to facilitate the design, management, and operation of water distribution systems (WDS). However, model parameters including pipe roughness coefficients (PRCs) and nodal demands (NDs) must be calibrated before practical applications, and the calibration accuracy and efficiency is important to enable their wide uptake in practice. This therefore motivates intensive studies to develop approaches for model calibration focusing on either optimization algorithms or numeric methods. Although these previous studies have advanced this research area, the calibration efficiency and effectiveness need to be further improved, especially when dealing with real-world problems. To attain this objective, this paper proposes an efficient numerical approach to simultaneously calibrate PRCs and NDs for WDS. Within this method, the calibration objective function is formulated as a least-square equation, followed by the derivation of iterative formulas according to a local sensitivity analysis. These formulas allow PRCs and NDs to be iteratively updated in an efficient manner until the given convergence criteria are met. To further improve the efficiency, the pipes and nodes are grouped according to their physical properties, which allows the calibration dimensions to be significantly reduced. Additionally, within the calibration process, values of PRCs and NDs are restricted into specified ranges to ensure the calibrated results are practically meaningful. Two case studies are used to demonstrate the utility of the proposed method, and results show that this approach is able to simultaneously calibrate PRCs and NDs efficiently, with the modeled hydraulic parameter values (pipe flows and nodal pressures) matching well with observations.

Pipe Friction Parameters Identification Method Based on Moore-Penrose Pseudo-Inverse Solution

Research on Friction Factors Calibration of Water Distribution System

Efficient Numerical Approach for Simultaneous Calibration of Pipe Roughness Coefficients and Nodal Demands for Water Distribution Systems

Pipe Resistance Coefficients Identification of Water Networks Considering Solvable Conditions

Pressure-balanced Saint–Venant Equations for Improved Asymptotic Modelling of Pipe Flow

Pipe Roughness Identification of Water Distribution Networks: The Full Turbulent Case

Pipeline parameter identification of non-stationary flows based on LabVIEW

Semi-analytical solution of pore-water pressure in unsaturated ground and infinite slope considering highly nonlinear soil hydraulic properties

Elastoplastic Pipe-Soil Interaction Analyses of Partially-Supported Jointed Water Mains

The Research of 1D / 3D Coupling Simulation on Pump and Pipe System

A unified friction factor formulation: Bridging laminar and turbulent friction factor with critical points analysis

Frequency-dependent Friction in Pipelines

Study on Impedance Identification of Pipes in Heat-Supply Networks

[Study on the Automatic Parameters Identification of Water Pipe Network Model].

Dynamic Analyses of Pipes in Saturated Soil under Traffic Loads

Identification of the Exchange Coefficient from Indirect Data for a Coupled Continuum Pipe-Flow Model

Effective method for identification of preferential flow paths in two-dimensional discrete fracture networks based on a flow resistance method

Pipe Hydraulic Resistances Identification of District Heating Networks Based on Matrix Analysis

Analysis and Application of Friction Calculation Model for Long-Distance Rock Pipe Jacking Engineering

Identification of centrifugal pump flow based on feature recognition

Reconstructing transient pressures in pipe networks from local observations by using physics-informed neural networks