Abstract:Introduction As major constituents of the Earth’s core, iron (Fe) and its alloys have long been of great interest to geophysicists [1]. Information on their high-pressure behavior, such as phase relations and equations of state (EOSs), is essential for interpreting seismic and geomagnetic observations and for numerical modeling of the Earth’s deep interior. Seismic observations coupled with laboratory research indicate that the density of the outer core and perhaps the inner core is lower than that of pure Fe, which has led to extensive research on possible lower-atomicweight components in the Earth’s core. Silicon (Si) has been suggested as a possible candidate for one of the light elements on the basis of geochemical evidence [2], and previous work has shown than the addition of a modest amount of Si (i.e., as little as 2-4 wt%) to Fe can have a profound effect on the Fe [3]. The EOSs of a number of Fe-Si alloys have been investigated recently [4]. However, the hydrostatic behavior of Fe-rich Fe-Si alloys had not been previously investigated. For the ε-phase, the axial (c/a) ratio is measure of configurational changes and is a good indicator of anisotropy. Accurate determination of the c/a ratio as a function of pressure is critical for investigating the possible origin of core anisotropy [5]. Hydrostatic measurements provide a better constraint on c/a for two reasons. Individual lines are sharper because of the reduced lattice strain, which results in a smaller d-spacing error. The effects of preferred orientation are also reduced, so the 00l lines, which are normally lost in the presence of uniaxial stress, are retained. This allows for the direct determination of c. In this article, we report on the results of a study on the compression (to 50 GPa) of Fe with 7.9 wt% Si at room temperature.

An assessment of the Fe-C-Si system

Critical Evaluation and Thermodynamic Re-Optimization of the Si–P and Si–Fe–P Systems

Cohesive, structural, and electronic properties of Fe-Si compounds

Thermodynamic assessment of the Mo‐Si system

A thermodynamic description of the Al–Fe–Si system over the whole composition and temperature ranges via a hybrid approach of CALPHAD and key experiments

Thermodynamic Reassessment of the C-Ni-Si System Using a Four Sublattice Model for Ordered/Disordered fcc Phases

Coupled Experimental Study and Thermodynamic Modeling of the Fe–Si–N System

Critical evaluation and thermodynamic modeling of the Fe–P and Fe–C–P system

CALPHAD-Type Reassessment of Cu-Si and Full Assessment of the Al-Cu-Si Systems

Experimental Phase Equilibria Studies in the FeO-Fe2O3-CaO-SiO2 System in Air: Results for the Iron-Rich Region

Experimental study of the phase relations in the Fe–Cr–Si ternary system at 700°C

Thermodynamics of Solid and Liquid MnS–CrS–FeS Phase in Equilibrium with Molten Fe–Cr–Mn–S Alloy

A Database for the Fe-Cr-Mo-Ni-N System

Thermodynamic descriptions of the CaO–Al2O3 and CaO–Al2O3–SiO2 systems over the whole composition and temperature ranges

Hydrostatic Compression of Fe-Si Alloy

First-principles study of bcc Fe-Cr-Si binary and ternary random alloys from special quasi-random structure

Experimental Investigation and Thermodynamic Calculations of the Co-Fe-Ti System

Thermodynamic Assessment of the Fe–Mn–Ni System and Diffusion Mobility of Its Face-Centered Cubic Phase

Critical Evaluation and Thermodynamic Optimization of the Cr–P and Cr–Fe–P Systems

Exploring the Relationship between the Structural Characteristics and Mechanical Behavior of Multicomponent Fe-Containing Phases: Experimental Studies and First-Principles Calculations

Evaluation of phase relationship in W-Fe-C ternary system through symmetry principles and first-principles calculation