Abstract:Using dynamic compression technique, the equation of state for Fe-8.6 wt% Si was measured up to 240 GPa and 4,670 K. A least squares fit to the experimental data yields the Hugoniot parameters C-0 = 4.6030.101 km/s and lambda = 1.5050.037 with initial density rho(0)=7.3860.021 g/cm(3). Based on the Hugoniot data, the calculated isothermal equation of state is consistent with static compression data when the lattice Gruneisen parameter gamma(l) =1.65(7.578/rho) and electronic Gruneisen parameter gamma(e)=1.83. The calculated pressure-density data at 300 K were fitted to a third-order Birch-Murnaghan equation of state with zero pressure the parameters K-0=192.16.3 GPa, K0'=4.710.27 with fixed rho(0 epsilon) =7.578 +/- 0.050 g/cm(3). Under the conditions of Earth's core, the densities of Fe-8.6 +/- 2.0 wt% Si and Fe-3.8 +/- 2.9 wt% Si agree with preliminary reference Earth mode (PREM) data of the outer and the inner core, respectively. These are the upper limits for Si in the core assuming Si is the only light element. Simultaneously considering the geophysical and geochemical constraints for a Si-S-bearing core, the outer core may contain 3.8 +/- 2.9 wt% Si and 5.6 +/- 3.0 wt% S. Plain Language Summary Silicon (Si) may be a dominant light element in the core, and precise evaluation of its amount requires accurate thermal equation of state of Fe-Si alloy. Here we present the Hugoniot data for Fe-8.6 wt% Si, measured up to 240 GPa with two-stage light gas gun. The experimental data allow us to establish reliable thermal equation of state of Fe-Si alloy over a wide pressure-temperature range and to constrain the composition of the core. The results indicate that the densities of Fe-8.6 wt% Si and Fe-3.8 wt% Si agree with the observed density profiles of the outer core and the inner core, respectively. Our model prefers an Fe-Si-S core that contains about 3.8 +/- 2.9 wt% Si and 5.6 +/- 3.0 wt% S in the outer core.

Hydrostatic Compression of Fe-Si Alloy

Hydrogen and Silicon Effects on Hexagonal Close Packed Fe Alloys at High Pressures: Implications for the Composition of Earth's Inner Core

Sound Velocities Of Fe And Fe-Si Alloy In The Earth'S Core

Electronic properties and compressional behavior of Fe–Si alloys at high pressure

Equation of State for Shocked Fe‐8.6 Wt% Si Up to 240 GPa and 4,670 K

Equation of state and phase diagram of Fe–16Si alloy as a candidate component of Earth's core

Electrical resistivity of hcp Fe-Si alloy at high pressure and temperature

Sound Velocities and Density Measurements of Solid Hcp-Fe and Hcp-Fe–si (9 Wt.%) Alloy at High Pressure: Constraints on the Si Abundance in the Earth's Inner Core

Melting phase relations in Fe-Si-H at high pressure: Implications for Earth’s inner core crystallization and core light elements

Crystal Structure and Phonon Density of States of FeSi up to 120 GPa

Shock Compression and Melting of an Fe‐Ni‐Si Alloy: Implications for the Temperature Profile of the Earth's Core and the Heat Flux Across the Core‐Mantle Boundary

Closure of the Fe–S–Si Liquid Miscibility Gap at High Pressure

Effect of Pressure on Crystal Structure and Phonon Density of States of FeSi

Sound velocity measurements of hcp Fe-Si alloy at high pressure and high temperature by inelastic X-ray scattering

Surface Tension of Superheated and Undercooled Liquid Co–Si Alloy

Effect of Si on liquid Fe compressibility: Implications for sound velocity in core materials

Sound Velocities of Fe‐Si Alloys at Conditions of the Cores of Moon and Mercury

Physical Properties of Liquid Fe Alloys at High Pressure and Their Bearings on the Nature of Metallic Planetary Cores

High-pressure behavior of the Fe-S system and composition of the Earth's inner core

Inner core composition paradox revealed by sound velocities of Fe and Fe-Si alloy

The Evolution of Microstructure, Micromechanical and Magnetic Properties of Feconisi Alloys Solidified under High Pressure