Abstract:In the field of radiowave detection, enlarging the receiver aperture to enhance the amount of light detected is essential for greater scientific achievements. One challenge in using radio transmittable apertures is keeping the detectors cool. This is because transparency to thermal radiation above the radio frequency range increases the thermal load. A technology that maintains cold conditions while allowing larger apertures has been long-awaited. We propose radio-transparent multi-layer insulation (RT-MLI), composed from a set of stacked insulating layers. The insulator is transparent to radio frequencies, but not transparent to infrared radiation. The basic idea for cooling is similar to conventional multi-layer insulation. It leads to a reduction in thermal radiation while maintaining a uniform surface temperature. The advantage of this technique over other filter types is that no thermal links are required. As insulator material, we used foamed polystyrene; its low index of refraction makes an anti-reflection coating unnecessary. We measured the basic performance of RT-MLI to confirm that thermal loads are lowered with more layers. We also confirmed that our RT-MLI has high transmittance to radiowaves, but blocks infrared radiation. For example, RT-MLI with 12 layers has a transmittance greater than 95% (lower than 1%) below 200 GHz (above 4 THz). We demonstrated its effects in a system with absorptive-type filters, where aperture diameters were 200 mm. Low temperatures were successfully maintained for the filters. We conclude that this technology significantly enhances the cooling of radiowave receivers, and is particularly suitable for large-aperture systems. This technology is expected to be applicable to various fields, including radio astronomy, geo-environmental assessment, and radar systems.

Two-layer anti-reflection coating with mullite and polyimide foam for large-diameter cryogenic infrared filters

Anti-reflection coating with mullite and Duroid for large-diameter cryogenic sapphire and alumina optics

Cryogenic infrared filter made of alumina for use at millimeter wavelength

Broadband Multi-layer Anti-reflection Coatings with Mullite and Duroid for Half-wave Plates and Alumina Filters for CMB Polarimetry

Wide-angle Broadband Antireflection Coatings with Nano-Taper Hydrated Alumina Film.

Anti-reflection Coating at 550 Nm Fabricated by Atomic Layer Deposition

Scratch-resistant Antireflective Coating for Mid-Wave Infrared Band

Broadband Absorption Coating for Large-Curvature Surfaces by Atomic Layer Deposition

Broadband plasma spray anti-reflection coating technology for millimeter-wave astrophysics

Design of A Panoramic Long-Wave Infrared Athermal System

Design and Fabrication of Infrared Hybrid Refractive/diffractive Optical System for 3-5Μm Band

Epoxy-based broadband anti-reflection coating for millimeter-wave optics

Broadband, millimeter-wave antireflection coatings for large-format, cryogenic aluminum oxide optics

Radio-transparent multi-layer insulation for radiowave receivers

Large-aperture wide-bandwidth antireflection-coated silicon lenses for millimeter wavelengths

Nanoporous antireflection coating for high-temperature applications in the infrared

Multi-layer anti-reflection coats using ePTFE membrane for mm-wavelength plastic optics

Optimizing the Efficiency of Fabry-Perot Interferometers with Silicon-Substrate Mirrors

Deep reactive ion etched anti-reflection coatings for sub-millimeter silicon optics

Athermal package for OH suppression filters in astronomy part 1: design