Abstract:Doping and alloying are important methodologies to improve the thermoelectric performance of FeNbSb based materials. To fully understand the influence of point defects on the thermoelectric properties, we have used density functional calculations in combination with the cluster expansion and Monte Carlo methods to examine the defect distribution behaviors in the mesoscopic FeNb1-xVxSb and FeNb1-xTixSb systems. We find that V and Ti exhibit different distribution behaviors in FeNbSb at low temperature: forming the FeNbSb-FeVSb phase separations in the FeNb1-xVxSb system but two thermodynamically stable phases in FeNb1-xTixSb. Based on the calculated effective mass and band degeneracy, it seems the doping concentration of V or Ti in FeNbSb has little effect on the electrical properties, except for one of the theoretically predicted stable Ti phases (Fe6Nb5Ti1Sb6). Thus, an essential methodology to improve the thermoelectric performance of FeNbSb should rely on phonon scattering to decrease the thermal conductivity. According to the theoretically determined phase diagrams of Fe(Nb,V)Sb and Fe(Nb,Ti)Sb, we propose the (composition, temperature) conditions for the experimental synthesis to improve the thermoelectric performance of FeNbSb based materials: lowering the experimental preparation temperature to around the phase boundary to form a mixture of the solid solution and phase separation. The point defects in the solid solution effectively scatter the short-wavelength phonons and the (coherent or incoherent) interfaces introduced by the phase separation can additionally scatter the middle-wavelength phonons to further decrease the thermal conductivity. Moreover, the induced interfaces could enhance the Seebeck coefficient as well, through the energy filtering effect. Our results give insight into the understanding of the impact of the defect distribution on the thermoelectric performance of materials and strengthen the connection between theoretical predictions and experimental measurements.

Enhancement in thermoelectric properties of FeSb2 by Sb site deficiency

Effect of Sb deficiency on the thermoelectric properties of Zn4Sb3

Transport and electrical properties of cryogenic thermoelectric FeSb2: the effect of isoelectronic and hole doping

Enhanced Thermoelectric Performance of Nonstoichiometric Compounds Cu3−x SbSe4 by Cu Deficiencies

Thermoelectric, mechanical and electrochemical properties of pure single-phase FeSb

Hot Deformation Induced Defects and Performance Enhancement in FeSb2 Thermoelectric Materials

Reduced thermal conductivity and enhanced TE performance in CrSb2via Fe-Bi co-substitution

Enhanced thermoelectric properties of FeTe 2 by Sb doping prepared by solid-state reaction

Enhancing thermoelectric performance of Cu1.8S by Sb/Sn co-doping and incorporating multiscale defects to scatter heat-carrying phonons

Defect induced structural and thermoelectric properties of Sb2Te3 alloy

Theoretical Study of Defects in Cu$_3$SbSe$_4$: Search for Optimum Dopants for Enhancing Thermoelectric Properties

Thermoelectric properties of Sb doped AlFe$_2$B$_2$

Modulated Fermi Level and Relaxed Lattice Strain Leading to Enhanced Thermoelectric Properties in AgSbSe 2

Effects of Sb Deviation from Its Stoichiometric Ratio on the Micro- and Electronic Structures and Thermoelectric Properties of Cu12Sb4S13.

Synthesis of Fe-Doped Tetrahedrites Cu<sub>12-x</sub>Fe<sub>x</sub>Sb<sub>4</sub>S<sub>13</sub> and Characterization of Their Thermoelectric Properties

Enhanced figure of merit for famatinite Cu3SbSe4 via band structure tuning and hierarchical architecture

Study for material analogs of FeSb$_{2}$: material design for thermoelectric materials

Realizing the Ultralow Lattice Thermal Conductivity of Cu3SbSe4 Compound via Sulfur Alloying Effect

Structure and thermoelectric properties of half-Heusler-like TiFeCu Sb alloys

Electronic structure and low-temperature thermoelectric transport of TiCoSb single crystals

Influence of defect distribution on the thermoelectric properties of FeNbSb based materials