Abstract:Thomson scattering x-ray source is an indispensable scientific X-ray imaging tool in various research fields. The 3-meter S-band linac in Tsinghua Thomson scattering X-ray source (TTX) has been running at an accelerating gradient of 15 MV/m so far. The gradient will be upgraded to 30MV/m by replacing the old structure with a shorter linac. Detailed optimization of the RF design of the new S-band linac structure is presented in this paper. Finally, further research on energy upgrade with X-band structures are also discussed. INTRODUCTION Advanced X-ray sources, such as X-ray free-electron lasers [1] and Thomson scattering facilities, are constructed in the world. These facilities can produce X-ray photos in keV energy. This will be widely used in biology, chemistry and material sciences with X-ray imaging technology. We have built the compact Thomson X-ray scattering source with mono-energetic electron beams and TW laser beam, which can get 10^7 photos in one single shoot [2]. The present beam line layout of TTX is showed in Fig. 1 (a). The operating proposal is to replace the old S-band travelling wave (TW) tube with a shorter one working in higher gradient and add two X-band accelerating structures after the structure. Upgrading layout of beam line is showed in Fig. 1 (b). Figure 1: Present linac layout and upgrade proposal. New design of S-band TW tube in 3π/4 mode has been adopted through electromagnetic calculation to get nearly 30 MV/m in the accelerating structure. The following section we will present electromagnetic design process of constant gradient structure design and its dual-feed coupler. ELECTROMAGNETIC DESIGN Completely procedure of designing the S-band TW tube starts with a single cell design. Simultaneously, optimizing the iris shape and thickness is essential in order to reduce iris surface field and lower breakdown rate. After single cell structure design finished, parameters adjustments of each cell separately is to achieve constants accelerating gradient in whole tube. Then, individually designing process of dual-feed coupler meet the demand of the cellchain design as microwave input/output port. In the overall design a continuous feedback between the electromagnetic design and realistic mechanical manufacturing procedure has been necessary.

Studies of the superconducting traveling wave cavity for high gradient LINAC

Three-cell traveling wave superconducting test structure

Optimization of a traveling wave superconducting radiofrequency cavity for upgrading the International Linear Collider

Backward Traveling Wave Electron Linac

Research On Backward Traveling Wave Electron Linac

Pulsed Superconductivity Acceleration

Design,fabrication,and Testing of Low-Group-velocity S-band Traveling-Wave Accelerating Structure

Study on SRF Multicell Accelerating Cavity for Linear Collider and Trapped Modes

A SW Ka-Band Linearizer Structure with Minimum Surface Electric Field for the Compact Light XLS Project

High-power performance studies of an S-band high-gradient accelerating cavity for medical applications

Fabrication, Tuning, and High-Gradient Testing of an X-band Traveling-Wave Accelerating Structure for VIGAS

Distributed Coupling Accelerator Structures: A New Paradigm for High Gradient Linacs

Superconducting Superstructure for the TESLA Collider: New Results

Achievement of 35 MV/m in the Superconducting Nine-Cell Cavities for TESLA

Development of 3-cell Traveling Wave SRF Cavity

High Gradient Testing of off-Axis Coupled C-band Cu and CuAg Accelerating Structures

HIGH CURRENT SUPERCONDUCTING CAVITY STUDY AND DESIGN

A Three-Cell Superconducting Deflecting Cavity Design for the ALS at LBNL

S-BAND ACCELERATING STRUCTURE FOR HIGH-GRADIENT UP- GRADE OF TTX

Great progress in developing 500 MHz single cell superconducting cavity in China

Design of a 10 MeV normal conducting CW proton linac based on equidistant multi-gap CH cavities