Abstract:This study investigated the failure behavior and mechanism of conductive and corrosion-resistant film on magnesium alloy under "double 85" test conditions. The surface morphology, microstructure, and composition of ITO composite conversion film (ITO film) at different damp-heat test times were analyzed using X-ray photoelectron spectroscopy, scanning electron microscopy and energy-dispersive X-ray spectroscopy, and the corrosion resistance was investigated using an electrochemical workstation in contact with a 3.5 wt.% NaCl solution. The electrical contact resistance (ECR) was measured using the four-wire Kelvin detection technique, and the bandgap was determined using an ultraviolet diffuse reflectance spectrometer. The results demonstrated that the ECR of the ITO film increased from 10 −1 Ω in −2 to 10 6 Ω in −2 , and the bandgap increased from 2.363 to 2.777 eV after the damp-heat test. In addition, the impedance arc radius of the film decreased to approximately one-fifth of its original value, and the impedance modulus value decreased to less than 10 4 . These findings indicated that exposure to a damp-heat environment resulted in an increase in the electrochemically active points within the film participating in the electrochemical reactions and expansion of the electrochemical reaction area. This exacerbated the corrosion of the magnesium substrate because it resulted in the destruction of the film, leading to an increase in the number of pores and defects, which heightened the exposure of the substrate to corrosive media. Furthermore, Cl − ions could easily penetrate through cracks in the film, which promoted charge transfer processes and accelerated the electrochemical corrosion reactions. In summary, these factors collectively resulted in the failure of the film's conductivity and corrosion resistance.

Novel optical and electrical combined calcium corrosion test: An industrial application of the barrier permeability of spotless water vapor

Feasibility of non-destructive testing for aluminium sheaths of HV cables using ultrasonic guided waves

Background noise analysis and improvement for the water vapor and oxygen transmission rate test of free-standing films

The Relationship Between Water Transmission Rate and Defects on the Film Based on the Defect Analysis Using Fluorescent Calcein Probe

Optical monitoring of water side permeation in thin film encapsulation

A Predictive Instrument for Sensitive and Expedited Measurement of Ultra-Barrier Permeation

A New Corrosion Sensor To Determine The Start And Development Of Embedded Rebar Corrosion Process At Coastal Concrete

A measuring method for B10 corrosion product film thickness and corrosion damage based on white light interferometer

A New Method for Measuring Multilayer Thickness Using a Chromatic Confocal Sensor

Anomalous Hopping and Tunneling Effects in a New Aluminum Film Percolation System

Defect Filling Method of Sensor Encapsulation Based on Micro-Nano Composite Structure with Parylene Coating

IC Surface Corrosion Inspection by C-Mode Scanning Acoustic Microscopy

An Electromechanical Impedance-Instrumented Corrosion-Measuring Probe

Influence of Water Film on Subsurface Defect Detection Using Eddy Current Pulsed Thermography

Study on failure behavior of conductive and corrosion-resistant conversion film on magnesium alloy in damp-heat environment

In Situ Nanoscale Characterization of Water Penetration Through Plasma Polymerized Coatings.

High-performance water vapor barriers via amorphous alumina-polycrystalline zinc oxide hybrids with a self-wrinkling morphology

Mechanical-Chemical Coupling Effects on an Environmental Barrier Coating System under High-Temperature Water Vapour Conditions

A Non-Destructive, Fast Evaluation of PVD Diffusion Barriers Deposited on Porous Low-K Dielectrics

Improved Current Sensor for Water Diffusion Testing of Composite Insulators

Microwave-based Non-destructive Testing Method on Composite Insulators