Measurement and Analysis of Metal Fittings Electrolytic Corrosion Current and Charge of Porcelain and Glass Insulators on HVDC Transmission Lines

Chenjun GUO,Daiming YANG,Hongwei MEI,Liming WANG
DOI: https://doi.org/10.13296/j.1001-1609.hva.2018.05.036
2018-01-01
Abstract:Electrolytic corrosion of hardware is always a problem in porcelain and glass insulators on HVDC trans-mission lines. Corrosion current and charge are for characterizing the corrosion rate and degree. The measurement principle and implementation method of them were analyzed. Then, a high accuracy and wide range equipment for corrosion current measurement was developed. The electrolytic corrosion test of insulators was carried out by salt spray method, and the corrosion current and charge were obtained. The data were compared and analyzed statistical-ly. The results showed that the current during electrolytic corrosion test in salt fog presented fluctuation and dispersion, and the corrosion charges were different among insulators. The difference is irrelevant to the mode of insulator suspension. In addition, an on-line monitoring system for corrosion charge was developed and installed on a ±500 kV HVDC transmission line. The corrosion current, charge, ambient temperature and humidity of the insulator string were obtained. Data analysis showed that with the increase of relative humidity, the average value of corrosion charge and current had two trends, one was obviously increasing, and the other is decreasing first and then increasing.
What problem does this paper attempt to address?